answersLogoWhite

0

If you mean a 'socket' or 'outlet' then nothing will happen unless the screwdriver blade is grounded, either by touching it or connecting it to the other side.This is NOT a very smart thing to do anyway.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

What happens when you put a 1100mA into a 400mA plug?

You die


How do you make the Remington wingmaster 870 hold more shells?

Take the plug out of the mag. unscrew the cap, pop out the spring stopper with a screwdriver. remove the spring and plug. Put the spring back in without the plug.


How do you replace freeze plugs in a ford 302 engine?

They can be replaced by popping the old plug in with a screwdriver, just 1 side of the plug then use a pair of pliers to pull it out. Then put silicone on new plug then line it up with the whole. Put a socket inside of freeze plug and hammer it into place. Some are harder than others but, it can be done.


Oil change on 2002 Audi A6 2.7T?

its like any other car but there is a belly shield underneath that can be taken out with a flat head screwdriver and you just remove the oil drain plug replace the oil filter and put the drain plug back in and fill with new oil its like any other car but there is a belly shield underneath that can be taken out with a flat head screwdriver and you just remove the oil drain plug replace the oil filter and put the drain plug back in and fill with new oil


How do you put screwdriver in a sentence?

Screwdriver help people to work fast


What happens if put fork in a plug?

You stand an excellent chance of receiving an electric shock and/or being electrocuted.


How do release a jammed sink plug?

Ram a screwdriver through it and pull it out.


Why should never place a metal in a plug socket?

it is a fatal risk of getting electrocuted if you insert any metal piece into a plug socket. Hence do not put any metal in to plug socket


How do you remove the knockout plug in a garbage disposal?

Punch out plug through drain opening on outside of disposal with screw driver or whatever will fit into opening to allow you to break out plug. Tap on screwdriver or whatever hard enough to break out plug. Remove plug from inside of disposal.


How do you check the transmission fluid level on a 1988 Suzuki Samurai?

there is a drain plug and a fill plug. fill the transmission until it is level with the fill plug. it you can touch it will your finger or a screwdriver it is full. make sure you dont fish the screwdriver at an angle toward the bottom. just kind of straight or slight angle.


What is the effort arm of a screwdriver prying of the lid of a paint can?

the effort is where u put work into the screwdriver- the handle.


Where do you put the crankcase oil in a 1997 400 Polaris Scrambler?

400 2 cycle has a couterbalanc that uses oil, dip stick/fill plug is under the caburator at the base of the cylinder should be a red plug with a screwdriver slot in it .Holds only about an ounce or so good luck