0
What else can I help you with?
What is heap -short?
The microprocessor architecture divides the memory into distinct areas. Heap is one of them. This is where you can statically/dynamically allocate memory.
What is the conversion of short-term memory to long-term memory called?
The conversion of short term memory to long term memory is called memory consolidation.
Is there a disease called short memory lost?
No there isnt. That is called Alzheimer
When information in memory is held for 15 to 25 seconds it is called?
Short-term Memory
What is another name for short-term memory?
Short term memory is also called primary or active memory. This type of memory stores data only for a short period time and it can only be a small amount of information stored at once.
What is 2 type of memory?
For Human Memory:1)Short-term2)Long Term3) SensoryFor Computers(Internal Memory):1)Random Access Memory2)Hard Disk Drive
What is the meaning of near and far definition in microprocessor programming using C?
Fundamentally any pointer in C is a reference to a memory location somewhere in system memory. While this seems simple in theory, in practice this is more complex when the microprocessor architecture is considered. Two considerations in computer programs are code size and speed. For this reason microprocessors have some additional modes which help reduce code and speed up code execution. Microprocessors fetch instructions from memory and then act on them. Included in these instructions are the addresses of the memory on which they will act. Modern microprocessors can access 2^32 memory locations (or more.) Thus a full memory location would take 32 bits to encode. The instruction may get quite large and take some moderate time to load from memory. To improve this situation the microprocessor manufacturers create instructions with "short" memory locations where part of the address is stored internally in a register in the microprocessor and the rest is held in this shortened address. These registers are called segment registers (in Intel processors) and the memory references are called relative addressing modes. This background finally brings us to the meaning of near and far. A near pointer reference is quick for the processor to handle but can only reference 64k bytes of memory. A far reference contains the entire memory location specified and can therefore specify memory anywhere in the microprocessor, it is however quite a bit slower to execute. This is less of an issue in modern processors but the choice becomes near and fast but only access 64k or far and slower but the entire memory map.
What are the two types of memory on a computer?
Internal and External. Internal - also known as Primary Memory, comes inbuilt when the computer is manufactured and mainly used to run the computer while external - also known as Secondary Memory can be added to the computer storing data and information for future use
What disorder does a patient have a short term memory loss?
It can be long term memory loss or retrograde memory loss. In either case it can be called amnesia.
Together short-term mental storage and manipulation operations are called?
working memory
Do monotremes have short internal development?
No, monotremes do not have short internal development.
What is considered the short-term memory used by the computer that is erased when the computer is shut down or rebooted?
That's called RAM (Random Access Memory). It is what's called 'volatile' memory - in that if power to the chips is removed, they lose their contents.
