It will forward the packet to the default gateway.
The default gateway on host A is incorrectly configured.
First, routing is the process a router performs when making forwarding decisions for each packet arriving at the gateway interface. To forward a packet to a destination network, the router requires a route to that network. If a route to a destination network does not exist on the router, the packet will be forwarded to the default gateway. Now, the destination network can be a number of routers or hops away from the default gateway. If the router has an entry for the network in its routing table, it would only indicate the next-hop router to which the packet is to be forwarded to and not the exact route to the final router. To sum it up, the routing process uses a routing table to map the destination address to the next hop and then forwards the packet to the next-hop address.
No, because without a default gateway configured the packet will never get to the router, and thus never get to the other network.
First, routing is the process a router performs when making forwarding decisions for each packet arriving at the gateway interface. To forward a packet to a destination network, the router requires a route to that network. If a route to a destination network does not exist on the router, the packet will be forwarded to the default gateway. Now, the destination network can be a number of routers or hops away from the default gateway. If the router has an entry for the network in its routing table, it would only indicate the next-hop router to which the packet is to be forwarded to and not the exact route to the final router. To sum it up, the routing process uses a routing table to map the destination address to the next hop and then forwards the packet to the next-hop address.
Ip address is 10.0.1.0 Gateway is 10.0.1.254 if not Try this update 01/30/2014 IP Address: 10.0.1.28 Subnet Mask: 255.255.255.0 Default Gateway: 10.0.1.254
a gateway can translate information between different networks data formats or network architecture. most gateways operate at the application layer. it can also be operated on network or session layer. by: talha jamal and farhan moin (kinpoe)
Employs traceroute-like to analyze IP packet responses to determine gateway ACL filters and map networks.
An originating host must determine if a packet should be sent directly to a host in the local network or be directed to the gateway.
--> If the destination network is directly connected, the router forwards the packet to the destination host. --> If no route exists for the destination network and a default route is present, the packet is forwarded to the next-hop router. --> If the originating host has a default gateway configured, the packet for a remote network can be forwarded using that route.
The gateway address is your router's inside local address. To find what your gateway and IP are you can open a Command Prompt (CMD) window and type "ipconfig/all" without quotes. Make sure you run the Command Prompt as an administrator when you open it.
When users sign into the internet they may not realize they are using a series of gateways to access their favorite websites. A default gateway is used a lot in office settings where a lot of computers need to be connected to both their internal network and the internet.