0
If it is the cabling within your system tower (or more commonly CPU), then I would suggest using sleeves since internal computer cabling usually needs rewiring with almost every change in the hardware or fault conditions. A heat shrink would severely limit this. At the same time, the air gun you would use to shrink could even damage the components near the cables if done improperly.
What else can I help you with?
How do you splice wires for headphones?
Solder the wires together and use heat shrink to insulate the soldered connection. You can buy heat shrink at any auto parts store or hobby store.
Do you need to do anything to the computer when you change the plugs and wires on a 2002 ford windstar?
No - the computer will notice some better sensor readings all by itself
What is an ordinary wrapped cable splice?
It sounds like it is simply two cable wires twisted together and insulated by wrapping the joint with insulating tape. If so, it is better to soldering the twisted bare wires and insulating the joint with a length of heat-shrink tubing.
If you cut the wires from the wire harness in a 1990 f150 what do you do to fix it?
what wires are they? If they are just regular wires like for lights or something, the best method is to solder them back together with rosin core solder and cover them with heat shrink tubing what wires are they? If they are just regular wires like for lights or something, the best method is to solder them back together with rosin core solder and cover them with heat shrink tubing
What Can I Do To Make My 2000 Mercury Mystique Accelerate Better?
You could change the spark plugs, sprak plug wires, computer chip.
What are the Computer wires and cables and circuits called?
The wires and cables in a computer are often, collectively called "innards" or "guts."
What is the Function of an Insulating sleeve?
An insulating sleeve is used to protect and insulate wires or components from electrical currents, heat, or other environmental factors. It helps prevent short circuits, overheating, and electrical hazards.
Heat-shrink tubing can it be used on wires going into fuel tanks?
No, What you can do is put a piece of shrink tube into a small amount of petrol for a period of time and observe the effect on the tube
What do you call the blood of computer?
Wires
How do you connect wires using a heat shrink connector?
A heat shrink connector is a small tube of translucent plastic shrink wrap with a small collar of solder in the middle. That's what I think the question is about. What you do is butt joint the wires together then use a soldering iron to melt the small collar of solder,this is what attatches the wires together in a more permenant bond than shrinkwrap alone. Then use a heat gun or other flame (carefully) to shrink the wrap around the wires and insulation. A proper heat shrink gun can melt solder inside the shrink without damaging it. 3M makes one. Tyco Electronics also makes one. Check out DigiKey and enter part # CWT9001-ND They are used in aircraft regularly. For the record, heat shrink is not plastic (I suppose it could be, but I've never seen it in 'plastic') for the most part it is polyolefin and comes in several types, shrink ratio of 2:1, 3:1, 4:1, 6:1.
What is a computer speaker made of?
Wires And A Amplifiers
What is the stamped number on the NIC inside your computer?
protocol wires hologaphic on inventions wires (hoiw)
