0
Yes with the proper tools you can splice two speaker wires together to extend the length of the wire. Be sure to use similar composition cable (copper to copper, silver to silver, etc) Wearing latex gloves to prevent corrosion form the oil on your skin strip 1/2in of the speaker cable sleeve on both cables. Twist the cables together and use silver solder to complete the bond. Apply heat-shrink of electrical tape to prevent the cable from shorting.
Enjoy your new, longer cable.
What else can I help you with?
Where is a magnet located on a speaker?
At the back of the cone where the wires connect in
What other things can speaker wires be used for?
Other things that speaker wires can be used for is power transmission. Speaker wires have negative and positive glued together in the insulation, it isn't intended for this purpose but can work.
My radio keep shorting out when i connect my front speaker wires on my 92 park avenue?
your wires maybe touching or the speakers are blown
How do you connect a homemade surround-sound speaker system together?
If speaker systems have Amplifier (home made).... Then you just combine their inputs so that ground couples with ground and signal input wires attached to the input wires or with connector.
What kind of wires are needed to connect computer speakers?
A cable wire that looks like a Y is needed to connect a laptop to a stereo. This cable allows you to use the single output jack on the laptop to connect to the left and right inputs on the stereo.
What colors are the positive and negative speaker wires on a 1998 Pontiac sunfire?
Each speaker has different colors from every other speaker. Which speaker do you need? Each speaker has different colors from every other speaker. Which speaker do you need?
How do you replace rear speaker 4 wire to a 2 wire grand am 2002 gt?
To replace the rear speakers in a 2002 Grand Am GT that has a 4-wire setup with a 2-wire speaker, you'll need to identify the positive and negative wires from the original 4-wire harness. Typically, two of the wires will be for each speaker (positive and negative). Connect the positive wire from the 2-wire speaker to one of the positive wires from the harness, and connect the negative wire to one of the negative wires. Ensure proper connections and insulation to avoid shorts.
Can you connect speaker wires that were previously cut in half together without effecting sound quality?
it can effect the quality of the speakers :) :)
How do you connect a Cambridge sounworks bass speaker?
To connect a Cambridge SoundWorks bass speaker, first ensure that your audio source (like a receiver or amplifier) is powered off. Use an RCA cable to connect the subwoofer output from your audio source to the subwoofer's input. If the subwoofer has speaker wire terminals, connect the speaker wires from your main speakers to the subwoofer's output, then connect the subwoofer to the power source. Finally, power on your audio equipment and adjust the settings as needed.
1990 Lincoln mark vii door speaker wires?
The speaker wires have 2 pin connectors that connect to the coaxial speakers in the doors.. If looking to upgrade speakers make sure you do research on the physical size of the new speaker as there might be issues. Also you can pick up a wire harness to connect the factory wire harness that is mounted to the door to a new set of speakers.
How do you connect one speaker to play both Right and Left output channels of a stereo amplifier and is there a bridging gadget I can purchase from Radio Shack or similar so that it sounds OK?
You can connect both left and right speaker wires to the one speaker but it will not sound very good but it will work.
What wire is positive when changing the speakers in a 2002 Saturn Vue?
Just use an old small battery lying around.With 2 wires,connect to speaker terminals.Now TOUCH Breify the other ends of the wires to that little battery. But watch the speaker.If you have hot on hot the speaker cone will push outward. If you have hot wire on negative speaker terminal the speaker cone will want to suck in. Sometimes the speaker will have one big terminal and a small terminal.The larger terminal is the hot side of the speaker.
