0
What else can I help you with?
Does a Local Area network uses a router?
The highest MAC address among the active interfaces of the network will be used. There will be no router ID until a loopback interface is configured. The highest IP address among the active FastEthernet interfaces that are running OSPF will be used. The highest IP address among the active interfaces will be used.
How do you obtain network id from IP address?
how do you obtain network id from ip address
What is true about the router ID in a single area OSPF network?
The router ID is used to uniquely identify each router in the OSPF routing domain.If no loopback interfaces are configured, the router chooses the highest active IP address of any of its physical interfaces.
What is a public ip different then network id?
An "ip address" is a complete source or destination address that has a network id portion and a client or host portion. The network id is just a piece of the IP address. So, a public ip is an IP address that can be routed, whereas the network id is just a part of the public ip. They aren't different; the network id is part of the ip address.
What is the host id of this IP address of 131.107.2.200?
Since this is a class C network address, the host id is 24, the network id is 201.123.87.0
How do you find the net id and host id of ip address 220.43.6.8?
To find the Network ID and Host ID from an IP address you need to use a Subnet Mask. The address 220.43.6.8 is a class C IP address (Since the range of Class C address is 192.0.0.0 to 223.255.255.255).The standard default mask for class C is 255.255.255.0Network address = (IP address) Boolean AND (Subnet mask)Hence,network address = 220.43.6.8 AND 255.255.255.0 = 220.43.6(since 255 means all 1s in binary, hence it'll give the same bits which are ANDed with it, whereas 0 means all 0s in binary, hence it'll give answer as 0 irrespective of what bits are ANDed with it)Hence Host Address would be the remaining part of IP address = 8
What should be the network ID if the IP address is 13.65.12.44?
If you aren't subnetting, the network address is 13.0.0.0
What is network id host id?
Network IDA network ID refers to a part of a TCP/IP address that is used to identify the subnet that a host may be on. The subnet that the computer is on is determined by the netmask and IP address of the computer. This subnet address is the same as the network ID and is the beginning part of the computers IP address.When the netmask is setup, it is a number where some of the most significant bits have a 1's value and the rest have values of 0. The most significant part of the netmask with bits set to 1's specifies the network address, and the lower part of the address will specify the host address.The part of the IP address that matches the part of the netmask where the bits are set to ones determines the network ID.
What are host id network id and broadcast id?
In networking, the network ID identifies a specific network segment and is used to route packets to the appropriate network. The host ID identifies a specific device (or host) within that network. The broadcast ID is a special address used to send messages to all devices on a network segment simultaneously, usually represented by the highest address in the subnet. Together, these IDs help in organizing and managing network communications efficiently.
Indicates where network information is located in an IP address?
The subnet mask is used for this purpose; it divides the IP address into two parts, the network id, and the host id.
Which class of id address provide a maximum of only 254 host addresses per network id?
Class C network
Which address in a network cannot be assigned to hosts?
The general rule in networking is that the network id cannot be all zeroes or all ones, and the host id cannot be all zeroes or all ones. The all zero address results in a reserved address meaning "this network". The all ones address is a broadcast address, and cannot be assigned to a single system.
