0
The default administrative distance for OSPF (Open Shortest Path First) is 110. This value is used by routers to determine the trustworthiness of a routing protocol's route information; lower values indicate more preferred routes. OSPF is commonly used in larger networks due to its efficiency and scalability.
What else can I help you with?
What is the default administrative distance for RIP?
120
What is the administrative distance of a default route?
The administrative distance of a default route is typically 1. This means that it is considered the most reliable and preferred route for forwarding traffic when no other more specific route is available in the routing table.
Which command allows a router to advertise default static routes via OSPF?
default-information originate
What command injects a default route into an OSPF network?
CCNA Guide to Cisco Networking Fourth Edition Ch.8 Answer: OSPF is configured using the router ospf [process id] command.
Which two commands can be used to modify the default OSPF metric calculation of a link?
The "ip ospf cost" command can be used to manually set the cost of an OSPF-enabled interface. The "bandwidth" command can indirectly affect OSPF metric calculation by adjusting the bandwidth on an interface, which in turn affects the OSPF metric calculation.
Is OSPF link state or distance vector or path vector protocol?
OSPF is a link-state routing protocol.
Which routing protocol has the most trustworthy administrative distance by default?
generally static routing protocol has the most trustworthy administrative distance .i.e; 1 and in dynamic routing protocols EIGRP has the best AD.
What is the default administrative value of rip?
120
What the administrative distance and metric for static route?
The administrative distance for a static route is typically 1, meaning it is very reliable and preferred over routes learned from dynamic routing protocols. The metric for a static route is typically one hop, meaning it has a fixed cost regardless of network conditions or traffic load.
What is the main difference between OSPF and RIP?
Both uses Distance vector algorithm...... . updates the routing table for every 30 seconds. and in OSPF requires hoping reneval of routing table
When is it possible to use administrative shares?
To use administrative shares you have to belong to a domain. Administrative shares only work on a domain and are default settings.
Which command shows the administrative distance of routes?
what command allows you to configure an administrative distance
