0
What else can I help you with?
What are the four possible configurations for four IDE devices in a system?
Primary IDE Channel , Master Device Primary IDE Channel , Slave Device Secondary IDE Channel , Master Device Secondary IDE Channel , Slave Device
What is secondary ide channel?
The secondary IDE channel is used to reference the other IDE channel apart from the primary one on a computer mainboard. While the primary IDE channel usually takes the system/first hard disk of the system, the secondary channel usually takes optical drives or the second hard drive.
What is secondary channel?
The secondary IDE channel is used to reference the other IDE channel apart from the primary one on a computer mainboard. While the primary IDE channel usually takes the system/first hard disk of the system, the secondary channel usually takes optical drives or the second hard drive.
What is channel id?
The secondary IDE channel is used to reference the other IDE channel apart from the primary one on a computer mainboard. While the primary IDE channel usually takes the system/first hard disk of the system, the secondary channel usually takes optical drives or the second hard drive.
How do you tell the difference between primary and secondary ide channel?
i dont know ask google
How many IDE controllers do most PCs have?
normally 2 IDE slots...
What is Primary IDE Channel?
The Primary IDE Channel component provides the IDEport driver in the atapi.sys file.The IDE port driver is part of the IDE driver model in Windows 2000
If a motherboard has one blue IDE connector and one black IDE connection which do you use to install a single drive?
Preferably to the IDE0 which most of the time is the Blue connector. The blue connector is primary, black is secondary
How many types of primary IDE?
there is IDE and EIDE. It is basically not that common these days.
What is the IDE channel to connect hard drives?
The best IDE channel to connect on a hard drive is the Primary IDE channel, Also known as IDE 1 in dell computers
What is the difference between master IDE and slave IDE?
Each IDE slot can handle two drives. One drive will be the master and the other will be the slave depending o the configuration. If the jumpers of one drive is configured to set the drive as MA (Master), the second must be configured to SL (Slave). Both drives may be configured as CS (Cable Select), if so, The positioning on the ribbon cable will determine whic one is the master and which is the slave
What should the primary jumper be set to On a primary IDE channel if a single hard disk is attached?
master if the ide cable has a single drive connection. if the ide cable has the master and slave connection. then set the drive to master with slave.
