0
RIPv1 (Routing Information Protocol version 1) has several limitations, one of the most significant being its lack of support for subnetting due to its reliance on classful addressing. This leads to inefficiencies, as it cannot provide routing updates for subnets or differentiate between networks of different sizes. Additionally, RIPv1 does not support authentication, making it vulnerable to routing table attacks. Its maximum hop count of 15 also limits its scalability in larger networks.
What else can I help you with?
List the 2 classful routing protocols and explain the most serious limitation of these two protocols?
IGRP and RIPv1
Can two applets access each other?
Because RIPv1 is a classless protocol, it does not support this access. RIPv1 does not support discontiguous networks. RIPv1 does not support load balancing. RIPv1 does not support automatic summarization.
Does VLSM support RIPv1?
ya if they are on both side then.. if one side then not..
How often does RIPv1 send out its routing table?
RIPv1 (Routing Information Protocol version 1) sends out its entire routing table every 30 seconds. This periodic update helps ensure that all routers in the network have the most current routing information. Additionally, RIPv1 uses broadcast to send these updates to all neighboring routers.
What will happen if an interface IP address is entered for the address portion of the network command in a RIPv1 configuration instead of a network address?
All interfaces in the same classful network as the configured address will be included in the RIPv1 routing process.
If you have 2 routers 1 ripv1 and 1 ripv2 will they talk to each other?
If you have two routers set up, one running RIPv1 and one running RIPv2, neither router will accept updates from the other. R1: (RIPv1) RIP: ignored v2 packet from 192.168.1.2 (illegal version) R2: (RIPv2) RIP: ignored v1 packet from 192.168.1.1 (illegal version)
What information is included in RIPv2 routing updates that is not included in RIPv1 updates?
subnet mask
What condition would RIPv2 allow that RIPv1 would not allow?
A 192.168.0.0/16 network
How does a router running a ripv1 determine the subnet mask of the routes that are recived in routhing updates?
RIPv1 is classful and will use the proper network mask based on the leading octet. For example 192.168.20.0 would have a mask of 255.255.255.0 because it is a class C
In comparing ripv1 and ripv2 message formats what is the only ripv2 message format field?
Subnet mask
What routing protocol updates routing tables about every 30 seconds resulting in overloaded network traffic?
RIPv1
What are the Limitation of the rule of the law?
Limitation
