0
What else can I help you with?
What is the default IO address for the primary IDE controller?
3F0 - 3F7Primary floppy disk drive controller. Primary IDE controller (slave drive) (3F6-3F7h)
What should the replacement optical drive be on the primary IDE controller?
If replacing the optical drive on a primary IDE controller, it is important it is compatible with the CD Rom drive. The IDE data cable must be connected and you must have the power cord plugged in.
What is the function of primary IDE controller?
The primary IDE (Integrated Drive Electronics) controller manages the communication between the computer's motherboard and its primary storage devices, such as hard drives and CD/DVD drives. It facilitates data transfer between the CPU and these drives, enabling the operating system to read from and write to storage media. The primary IDE controller typically supports multiple devices through a master/slave configuration, allowing efficient management of storage resources.
What standard must an ide bus controller and CD-ROM drive support in order to boot from CD?
El Torito
What is standard dual channel pci ide controller?
A standard dual channel PCI IDE controller is a hardware component that enables communication between the computer's motherboard and IDE (Integrated Drive Electronics) devices, such as hard drives and optical drives. The "dual channel" aspect allows it to connect two IDE devices simultaneously, enhancing data transfer rates and efficiency. This controller interfaces with the system via the PCI (Peripheral Component Interconnect) bus, facilitating the integration of older storage technologies in modern systems. It is commonly used in legacy systems that require support for IDE devices.
What standard is also called parallel ata?
Parallel ATA (sometimes called PATA) is synonymous with IDE or EIDE (Integrated Drive Electronics or Enhance Integrated Drive Electronics). IDE was the first technology to include the controller and hard drive in the same housing; previously with SCSI, MFM and RLL drives, the drive and the controller were separate.
How many IDE controllers are typically built into an ATX motherboard?
it has 2 IDE controller
What is an IDE controller?
IDE (Integrated Device Electronics) is a standardized interface for data storage devices in computer systems. It is so named because much of the logic circuitry is integrated into the device itself. IDE is most commonly used for hard drives and CD or DVD drives, but has also been used for tape drives and zip drives. An IDE controller is the primary interface (usually integrated into the motherboard) which any IDE devices will be plugged into. It handles the flow of data to and from these devices. It usually consists of two connections (known as IDE channels) both of which can handle up to 2 devices each. It is also possible to add more IDE controllers in the form of PCI or PCI-E cards, these are usually referred to as IDE controller cards. This is often done to enable more storage devices to be installed into the system, but may also be done to replace an obsolete or malfuntioning on-board IDE controller.
How many IDE devices can you have?
Short answer: Four A much more precise answer: The IDE standard allows for two devices to share a single IDE channel. The most common configuration is for there to be two IDE channels on the motherboard, allowing for a total of four devices. It is possible however, to add more IDE channels, usually in the form of PCI add-on IDE controller cards and have literally dozens of IDE devices in a single computer system.
What is Primary IDE Channel?
The Primary IDE Channel component provides the IDEport driver in the atapi.sys file.The IDE port driver is part of the IDE driver model in Windows 2000
What is the function of the IDE cable?
IDE (Integrated Drive Electronics) is a standard electronic interface used between a computer motherboard's data paths or bus and the computer's disk storage devices. The IDE interface is based on the IBM PC Industry Standard Architecture 16-bit bus standard, but it is also used in computers that use other bus standards. Most computers sold today use an enhanced version of IDE called Enhanced Integrated Drive Electronics. In today's computers, the IDE controller is often built into the motherboard.
How many devices can be added to a typical IDE controller?
4
