answersLogoWhite

0

Length over which the column has no support is taken as unsupported length of the column

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you calculate column volume?

Multiply column inside diameter by the column's length. Then convert to units you need. The above is not correct.The volume of a column is the circular area of the column multiplied by the length, pi*radius^2*length.


What is the column length column to column of the Great Wall of China?

5 inches


Why is the length of air column increased slowly?

The length of the air column is usually increased slowly because of resonance.


What is anchorage length?

This is the additional length of steel of one structure required to be inserted in other at the junction. For example, main bars of beam in column at beam column junction, column bars in footing etc. The length requirement is similar to the lap length mentioned in previous question or as per the design instructions.


What is the minimum anchorage length for reinforcement?

It is the length of the main bar provided at the column beam junction or column footing junction to allow for the development of stresses to its design strength.


How much lap length in RCC vertical column in all dia?

At what length lapping is to be provided


How do you convert centimeter to L?

Centimeter is a measurement of length. L - assuming you mean "liter" is a measurement of volume, which is length cubed. L - assuming you mean column length, is the length of chromatography column in HPLC or capillary in CE used to perform the liquid-phase separation, which can be measured in centimeters. Note that in some cases the actual column may be longer than the portion that is performing separation, i.e. some of the column may be effectively "empty" and should not be used in calculations requiring the length over which separation is occurring. In that case, only the packed or lined portion of the column should be used for the measurement.


What is the formula to calculate the length of lateral ties in column?

The length of lateral ties in a column can be calculated using the formula: ( L = 2h + 2b + 4d ), where ( L ) is the total length of the ties, ( h ) is the height of the column, ( b ) is the width of the column, and ( d ) is the diameter of the tie bars. This formula accounts for the vertical and horizontal lengths needed to secure the ties around the column. Ensure to adjust for any specific design requirements or spacing as per applicable codes.


How to calculate the force inside a column being pressurised by a pump. Do we have to include the length of the column in the calculation. Say the column was 3 metres tall the pressure was 3000 psi?

no the column length does not matter. All that matters is the pressure inside it (I'm assuming it is a hollow column with a piston inside), and the cross sectional area inside the column, equal to the surface area of the piston. If you're talking about a hollow tank shaped like a cylinder and a pump is pressuring it up, then the length may matter. What "force" are you talking about?


Formula effective length of a column with both ends fixed?

0.5l


What kind of adult have a spinal column running the length of the body?

snakes


A 10cm column of air trapped by a column of mercury of 8cm long in capillary tube horizontally at 1 atmospheric pressure The length of air column when the tube is fixed vertically with open end up?

The pressure exerted by a column of mercury is given by the equation P = hρg, where h is the height of the column, ρ is the density of mercury, and g is the acceleration due to gravity. Since the pressure inside and outside the tube remains the same, the length of the air column will be the same when the tube is fixed vertically. Therefore, the length of the air column will be 10 cm.