The answer varies according to bios and manufacturer.
press the setup button until it switches to life, then press reset, if the oil life is already up press reset first then press setup until it switches to oil life, then reset again
To access the CMOS setup on an HP ProBook 4520s, restart the laptop and press the "Esc" key repeatedly as it boots up. When the Startup Menu appears, press "F10" to enter the BIOS setup. From there, you can navigate through the CMOS settings using the arrow keys. Be cautious when making changes, as this affects system configuration.
To reset the clock in a Mk5 Fiesta, turn on the ignition without starting the engine. Press the "Menu" button on the stereo until you see the clock display. Use the "Tune" or "Seek" buttons to adjust the hours and minutes, then press the "Menu" button again to save the changes. If your model has a different setup, consult the owner's manual for specific instructions.
To change the time in a 2006 Jeep Liberty, turn on the ignition but don't start the engine. Press the "SETUP" button on the radio until the display shows the clock settings. Use the "TUNE" knob to adjust the hours and minutes, then press "SETUP" again to save the changes. Finally, turn off the ignition to exit the settings mode.
Press Page Layout tab to expand, then adjust settings in Page Setup section.
1. Open the tray 2. Press SETUP 3. Press 1 3 8 9 4. With the arrows change the region code 5. Press SETUP 6. Close tray
a Floppy Disk
On mine, you press SETUP twice and then press and hold RESET
To change the clock time on a 2012 Subaru Outback, first, turn on the vehicle's ignition. Then, press and hold the "SETUP" button on the audio system until the clock display begins to blink. Use the "TUNE" knob or the "SEEK" buttons to adjust the hour and minute. Once the correct time is set, press the "SETUP" button again to save the changes.
Just go to "character info and setup" and then in the top press "stats instead of "loadout" and the press reset stats
1. Turn on tv 2. Press and hold the setup button until red light stays on then release the setup button 3. Press the the desired mode button. ( tv, VCR ect.) 4. Press the channel UP button repeatedly till channel changes. (may take up to 300X 5. Press the mute button.
Weekly-Monthly