Plenty of older processors have had 1GHz FSB. Intel Celeron is one of them.
The following are requirements for this game: Intel® Pentium® III processor, a speed of 1GHz, Windows 98, Windows 2000, Windows XP, or Windows Vista, and a memory of 512MB RAM.
The period of 1GHz is 1 ns. The waveform is irrelevant.
1ghz is faster then 600 mhz Edit- Not really. A 1GHz processor cycles through instructions faster, but take this for thought. What if you have Processor 1, which is at 1GHz but does 2 operations per cycle. This processor has a small L1 Cache and a high cache miss rate. Lets say this is a 16-bit processor with an 8-bit bus width (Older desktop processors) Processor 2 runs at 600MHz but does 4 operations per cycle, a large L1 Cache, and an extremely low cache miss rate. This is a 32-bit processor with a 16-bit bus width (Older server processors) Processor 2 will be more than TWICE as fast in actual performance. Don't go by the GHz / MHz readings alone.
well an iphone 3gs is only 600mhz (0.6ghz) so yes 1ghz is very good. most phone brands are going with a snapdragon 1ghz on theirr higher end models now
1GHz Apple A4 custom-designed, high-performance, low-power system-on-a-chip -apple.com
1000000000
Will do its job, but its outdated
1GHZ - 2GHZ MHz processor (Intel Xeon Processor) 512 MB- 2 GBRAM memory 40- 120 gig IDE / SCSI Hot swappable disk drive 56k modem DVD Ram IDE drive 10-20 Backup Disks .net (2003)Operating System Battery Backup
If there are newer processors in the same product range as the 900 MHz model, and they use the same socket and FSB (Front Side Bus) speed, then yes, you probably can.Without knowing your specific motherboard model, though, it would be impossible to determine if this is the case for you.
this could be for a number of reasons. Primarily, the PC in question could not support the new hardware. IE you have a Pentium 3 (socket 370) motherboard, which takes a max of 500mhz CPU, and your attempting to install a 1ghz CPU in it. Drivers for the PC could not be found. Installation error. Hardware error. hope this helps be safe
1000Mhz is equivalent to 1Ghz. Therefore 100Mhz is equivilent to 0.1Ghz