0
What else can I help you with?
Which part a network layer address does the router use during path determination?
The network address
What assigns IP address to network?
Usually the router.
Which OSI layer defines the functions of a router?
Network Layer - Does path determination and logical addressing.
How do you setup eigrp protocol?
router#config t router(config)#router eigrp 100 #net NETWORK ADDRESS
Will including a router improve computer security?
A router can improve network security if it includes the use of NAT (network address translation) and/or a firewall.
Why can a router have a single mac address but many IP address?
The Router only has one M.A.C Address and One IP Address But, the Router can have many Connections ( Devices using the network ) That may shoe up as their IP Addresses. But the Router only Has One IP Address
What address does the router use to compare to the routing table?
in general the router uses the network address to compare to the routing table. Specifically, on the internet, the Router looks up the destination IP address in the router table to determine where to route the packet.
In an IPv4 environment what information is used by the router to forward data packets from one interface of a router to another?
It uses the MAC address, Media Access Control. Every packet sent from a computer contains its MAC address. The router stores this in its routing table. When it receives a packet with a destiation address of that MAC address, then it forwards it to that computer. This is called NAT, Network Address Translation. It uses the Destination IP address
How do you configure RIP routing protocol on a Cisco router?
Here is a basic overview of the configuration of RIP on a Cisco router:Router(config)#router ripRouter(config-router)#network 192.168.1.0Router(config-router)#network 192.168.2.0Router(config-router)#network 192.168.3.0Router(config-router)#network 192.168.4.0Router(config-router)#network 192.168.5.0The 192.168.x.0 address can be changed to whatever address you would like to be broadcast over RIP. There are also other settings that can be configured.If you use RIPv2 you can also have the following configuration:Router(config)#router ripRouter(config-router)#version 2Router(config-router)#network 192.168.1.0Router(config-router)#network 192.168.2.0Router(config-router)#network 192.168.3.0Router(config-router)#network 192.168.4.0Router(config-router)#network 192.168.5.0Router(config-router)#exitRouter(config)#exitRouter#%SYS-5-CONFIG_I: Configured from console by consoleRouter#copy running-config startup-configDestination filename [startup-config]?Building configuration...[OK]Router#
To which network device or interface does the IP address 192.168.1.254 belong?
That is normally the IP address of a router
When a host on network A sends a message to a host on network B which address does the router look at?
When a host on network A sends a message to a host on network B, the router looks at the destination IP address in the packet’s header to determine where to forward the message. This IP address is used to identify the specific network and host within that network. The router uses its routing table to decide the best path for the packet based on this destination IP address. The MAC address is not used for routing between different networks, as it only applies to the local network segment.
Is your ip address assigned to your router or to each computer on the network?
Your Router is assigned an IP address that is known as a public IP address then your router assigns out IP addresses that are known as local IP addresses. So the answer is yes and yes!
