answersLogoWhite

0

The two outside contacts (of four contacts) are connected to the power supply in the computer.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

What provides greater power to the Bus Firewire or USB?

FireWire generally supplies more voltage, at a maximum of 30 volts. USB provides a maximum of 5 volts.


What is usb bus power?

The Voltage at which the USB Drive works at.


What are the voltage requirements for a UK USB plug?

The voltage requirement for a UK USB plug is typically 230 volts.


USB 2.0 is how many times faster than USB 1.1?

usb 2.0 is about 40 times faster than usb 1.1


Constant voltage power supplies will maintain a constant voltage under varying?

current.


When a battery does 24j of work on 10c charge the voltage it supplies is?

voltage=joule/coulomb or voltage=24/10. the answer is 2.4V


How much voltage can a USB port on a PC typically supply?

5v


At what voltage does a USB host supply power to the USB bus?

Pin 1 is 5 volts DC Pin 4 is ground.


What is the voltage that supplies a motor starter called?

In the electrical trade it is called control voltage. This voltage can be any voltage. In North America the common control voltage is 120 volts.


What is the voltage of a USB?

Clients have to accept 4.75 to 5.25V and must be able to send configuration data as low as 4.4V. Hubs are allowed to drop as much as 0.35V. By itself, a USB plug does not have to supply more than 100mA; however up to 500mA can be negotiated between device and host. Some USB hosts simply offer up 500mA from the get-go. USB power supplies short the two data lines (white and green) which allows the device to probe for the fact that they're power supplies (i.e. that they provide the full 500mA without negotiation and that they won't respond to data).


What are the two main types of voltage in use in the UK?

In the UK, the two main types of voltage in use are 230 volts for domestic supplies and 400 volts for industrial supplies.


What happen to the output voltage of the DC power supply if turn ratio in the secondary winding are reduce?

For linear supplies, the straightforward answer is: THE VOLTAGE GOES DOWN. For regulated unipolar switching supplies (all bets are off), it is likely that your pulse width will increase until you are at the regulated voltage set at the chip. Not all DC supplies behave the same way.