0
Typically a 2, or 3 pin 'fan' connector, or a 4-pin 'molex' connector.
The 2-pin (positive/negative) and 3-pin (positive/negative/RPM) are most common, but older or cheaper fans, especially those not used on the CPU heatsink, may use a 4-pin 'Molex' connector.
Other connectors may be used, including proprietary connectors, in the case of some motherboards, CPUs, and cases.
This is common in videocards, which may need 2/3 pin, 4-pin molex, 4-pin PCI-E, 6-pin PCI-E, or 8-pin PCI-E connectors, or a combination thereof!
What else can I help you with?
What does a heat pump look like?
A heat pump in the home will be the air conditioning compressor. It will be a heavy unit that is usually square to cylindrical and attached to cooling tower assembly.
How is solar power collected and stored?
Solar power is collected by solar panels, and stored in currents
What generates the most heat in a computer?
It highly depends on the computer, but it's usually either the GPU, Power Supply or CPU. With GPU and Power Supply generating the most heat normally.
What term is used to describe how much heat a circut dissipates?
The term used to describe how much heat a circuit dissipates is "power dissipation." It refers to the amount of power that is converted into heat as the circuit operates, usually measured in watts.
With a fully charged battery.When you turn the key it kills all the power in the car and you have to disconnect the battery then reconnect it to have power again why?
you have corroded battery cable connector feel for heat when trying to start the bad cable will get hot or smoke
In a practical machine the power output is equal to the power input?
No, because of inefficiencies which usually cause heat, or heat in unwanted places. Or wear of parts. The total power in always appears somwhere in some form, not always where it is wanted.
What happens to the power used in a circuit?
Usually dissipated as heat. Can be converted into light, motion, sound, etc.
What is a reactor?
A nuclear reactor is an assembly of fuel elements (uranium usually), a moderator which can be ordinary water, heavy water, or graphite, and control rods. The reactor is made to reach criticality when uranium fuel will produce a steady power output as a result of nuclear fissions which release heat. The heat is used to produce steam which feeds a conventional steam turbine/generating unit.
Replacing Heating element Maytag DE410 Dryer?
Unplug dryer! Yes the electrical cord. On front panel, remove two small screws located at bottom. Swing out front panel and about 45 degrees move panel away front dryer. The heat element coil assembly is at the bottom right side of dryer. Disconnect the two main wires from the heat element. Remove four small screws holding the heat element assembly. Two screws are located in the front cover of the heat element assembly , one is in the far end of the assembly and one is inside the assembly. The heat element assembly can now be remove from the dryer.
what is the best wire connector to use?
High Heat Porcelain Wire Connectors are very safe.
Where does a candle get its power to give off heat and light?
A candle gets its power to give off heat and light from the chemical reaction that occurs when the candle wax (usually made of hydrocarbons) is burned. The heat generated from the flame melts the wax, which then vaporizes and combusts with oxygen in the air to produce heat and light energy.
What is reactors?
A nuclear reactor is an assembly of fuel elements (uranium usually), a moderator which can be ordinary water, heavy water, or graphite, and control rods. The reactor is made to reach criticality when uranium fuel will produce a steady power output as a result of nuclear fissions which release heat. The heat is used to produce steam which feeds a conventional steam turbine/generating unit.
