You will most probably need to call your computer's manufacturer or in the case you built your own system, your motherboard manufacturer.
There are many places one can purchase jumper cables on line or in store. One can buy them from Walmart, Home Depot, Sears, or Amazon. One can also buy them new or used from ebay.
wear did Katie price buy her silver jumper dress she is wear in this week front cover of heat magazine
The BIOS will inform CMOS when there is a new installation with auto detection.
If it's a desktop PC, erasing the cmos memory will usually clear it. Turn the power off, remove the cover. There should be a battery, these days they use a large silver disc watch battery type. Near it should be three pins with a linker on two of them. Move it to the other side, so the middle pin is linked to the other pin. Leave it there for a few seconds and then put it back in it's original position. Replace the covers and boot up. You will then have to reset your BIOS options etc.. On Laptops, they all most always write the password to EEROM or flash memory, which don't need a battery. Unfortunately, sometimes the only way to clear these, is to remove the chip and use a programmer to load it with the latest BIOS from the manufacturer or replace it with a new one. Dell computers have a master password which is unique to each computer. That password can be obtained from Dell customer service.
To remove the CMOS battery from an HP Pavilion dv2 notebook, first, power off the device and disconnect it from any power source. Open the back cover by unscrewing the screws and carefully lifting it off. Locate the CMOS battery, which is typically a coin-cell battery; gently disconnect it from its socket. Replace it with a new battery if necessary, then reassemble the notebook.
This information is intended for experienced users. It is not intended for basic users, hackers, or computer thieves. Please do not try any of following procedures if you are not familiar with computer hardware. I'll not be responsible for the use or misuse of this information, including personal injury, loss of data or hardware damage. So use it at your own risk. A. By Using the Motherboard Jumper: In most motherboards CMOS battery is soldered, which makes it difficult to remove the battery. In this case we use another method. Almost all motherboards contain a jumper that can clear all CMOS settings along with the BIOS password. The location of this jumper varies depending upon the motherboard brand. You should read your motherboard manual to check its location. If you don't have the manual then look for the jumpers near the CMOS battery. Most of the manufacturer label the jumper as CLR, CLEAR, CLEAR CMOS, etc. When you find the jumper, look carefully. There will be 3 pins and the jumper will be joining the center pin to either left or right pin. What you need to do, is remove the jumper and join the center pin to the opposite pin. e.g. if the jumper joins center pin to left pin, then remove it and join center pin to right pin. Now wait for a few seconds and then again remove the jumper and join the center pin to left pin. Make sure to turn the PC off before opening the cabinet and resetting the jumper. B. By Using Software: I have found that BIOS/CMOS Password Recovery Tool is the most effective.: BIOS/CMOS Password Recovery Tool is a program that works instantly to remove any lost or forgotten BIOS/CMOS password. Simply boot your PC to DOS and execute the program, and get access to forgotten BIOS/CMOS passwords in just seconds BIOS/CMOS Password Recovery Tool Service
Get a new jumper, that should not happen!
This information is intended for experienced users. It is not intended for basic users, hackers, or computer thieves. Please do not try any of following procedures if you are not familiar with computer hardware. I'll not be responsible for the use or misuse of this information, including personal injury, loss of data or hardware damage. So use it at your own risk. A. By Using the Motherboard Jumper: In most motherboards CMOS battery is soldered, which makes it difficult to remove the battery. In this case we use another method. Almost all motherboards contain a jumper that can clear all CMOS settings along with the BIOS password. The location of this jumper varies depending upon the motherboard brand. You should read your motherboard manual to check its location. If you don't have the manual then look for the jumpers near the CMOS battery. Most of the manufacturer label the jumper as CLR, CLEAR, CLEAR CMOS, etc. When you find the jumper, look carefully. There will be 3 pins and the jumper will be joining the center pin to either left or right pin. What you need to do, is remove the jumper and join the center pin to the opposite pin. e.g. if the jumper joins center pin to left pin, then remove it and join center pin to right pin. Now wait for a few seconds and then again remove the jumper and join the center pin to left pin. Make sure to turn the PC off before opening the cabinet and resetting the jumper. B. By Using Software: I have found that BIOS/CMOS Password Recovery Tool is the most effective.: BIOS/CMOS Password Recovery Tool is a program that works instantly to remove any lost or forgotten BIOS/CMOS password. Simply boot your PC to DOS and execute the program, and get access to forgotten BIOS/CMOS passwords in just seconds BIOS/CMOS Password Recovery Tool Service
You could buy a new hot tub cover almost anywhere. You could start by checking out your local pool and spa dealer, or asking friends and family who also have a hot tub.
http://cgi.ebay.com/NEW-OEM-SAMSUNG-S5600-BATTERY-DOOR-BACK-COVER-White_W0QQitemZ250509742886QQcmdZViewItemQQimsxZ20091007?IMSfp=TL091007134003r12903
Bail Jumper - 1990 was released on: USA: 13 April 1990 (New York City, New York)
will auto detect it