0
On a 2004 Renault Clio, the refrigerant pressure sensor is typically located on the air conditioning system's high-pressure line. It is attached to the metal line that runs from the compressor to the condenser, usually near the engine bay. You may need to remove some engine covers or components for easier access. Always consult the vehicle's service manual for precise location and handling instructions.
What else can I help you with?
Where is the mass air flow sensor on 04 Ford Taurus?
In between the radiator and the tire pressure gauge.
Where is the oil pressure sender on a 04' cavalier ls?
The oil pressure sensor screws into the block. It is mounted close to the oil filter and should be easy to reach.
Egr pressure sensor location on 2004 F350 powerstroke turbo diesel?
The exhaust back pressure sensor or EBP on the 04 is located by the upper radiator hose by the block. It has a 3 pin connector and accepts a 24mm socket.
What size are the front speakers on a clio 04?
13cm - 5 1/4"
Where is the paint code on a clio 04?
No plate on the bulkhead ? Then have a look on the pillar of the front left door, there should be a sticker there with the info.
Where is the oil pressure switch on a 2004 Chevrolet avalanch 5.3L?
you mean the sensor at the engine? try the Chevy website- there was a major recall on the 04 aval instrument cluster-good luck
Where the oxygen sensor circuit fuse on 04 silverado 2500hd?
were is the fuse located for the O2 sensor
Were does the map sensor located at 04 ford free star?
where is the map sensor located on a ford freestar
Code for PO137 bank 1 sensor 2 where is this sensor located driver or passenger side on 04 dodge ram?
Sounds like a clooged filter or a weak fuel pump. Replace the Fuel Filter. Install a fuel pressure gauge on the fuel rail and check it under load. If the pressure drops even a little the fuel pump is bad.
When was Increase the Pressure created?
Increase the Pressure was created in 1984-04.
How do you add freon to an 04 Chevy classic?
To add Freon to a 2004 Chevy Classic, first ensure the engine is off and the A/C system is off. Locate the low-pressure service port, typically found on the larger A/C line, and connect a refrigerant gauge or canister with a hose. Start the engine and turn the A/C to the maximum setting, then slowly open the refrigerant canister to allow Freon to flow into the system while monitoring the pressure gauge. Once the recommended pressure is reached, disconnect the canister and replace the service port cap.
Where is knock sensor Chevy Blazer 04?
Check the owner's manual.
