The water temperature sensor in a 2001 Mazda Millenia is typically located near the thermostat housing, which is situated on the engine block. It is often found at the front of the engine, near the intake manifold. To access it, you may need to remove some components, such as the intake duct or other nearby parts, depending on the specific engine configuration. Always refer to the vehicle's service manual for precise details and instructions.
how to change speedometer sensor on mazda millenia 2000 2.3 v6
where is the water pump located in Mazda millenia
On the transmission output shaft housing on the side closest to the firewall.
It is on the dash in front of the steering wheel,it looks like a small black bump.
Most knock sensors are located in the block on the firewall side. Should be the only sensor with two wires in the block. It will also have a camshaft position sensor as well. Hope that helps. I am not educated on Mazda engines.
On the 2000 Mazda Millenia, the engine temperature sensor is typically located near the thermostat housing. It is usually situated on the engine block or cylinder head, often connected to the cooling system. To access it, you may need to remove some components or covers, depending on the specific configuration of the engine. Always refer to a service manual for precise locations and steps specific to your vehicle.
The throttle position sensor is on the throttle body.
replace your MAF sensor.
It is a nonservicable part, just replace it.
in da tank
call your local dealer
no sgc signal. cam position sensor