0
On a 1994 Oldsmobile Achieva S, the knock sensor is typically located on the engine block, near the cylinder head. It is often found on the lower part of the engine, towards the front or side, depending on the specific engine configuration. To access it, you may need to remove some components for better visibility. Always refer to the vehicle's service manual for precise location and removal instructions.
What else can I help you with?
Does a 94 integra have a knock sensor?
LS does not have a knock sensor. GSR does have a knock sensor
Is their a Throttle position sensor on a 94 achieva?
yes
Why do your headlights not work on your 94 Oldsmobile achieva?
probably just burnt out bulbs
How do you replace the radiator on a 94 Oldsmobile acheiva s?
How do you replace an 1994 3.1 Oldsmobile Achieva s radiator?
What tools do you need to remove a starter for 94 Oldsmobile achieva?
Common hand tools.
Where is knock sensor located on 94 S-10 2.2L?
Knock sensor = CKP sensor on this vehicle.
Where does a turn signal flasher go in a 1992 Oldsmobile Achieva?
It should be the same as a '94 Achieva and it is under the dash by the sterring column. You have to look real good to find it
Your 94 Oldsmobile Achieva gets water on the floorboards where is it coming from?
Most likely your heater core has gone bad.
Where is the knock sensor on a 94 Nissan pickup?
Its up in under there somewhere
Esc module location 94 Chevrolet 1500 and wire color for knock sensor?
Looking for the ESC myself....the Knock Sensor wire is blue though.
Where is the oil pressure sensor on a 94 achieva?
On a 1994 Oldsmobile Achieva, the oil pressure sensor is typically located near the oil filter, on the engine block. It is usually positioned on the driver's side of the engine, towards the back. To access it, you may need to lift the vehicle or remove any components that obstruct your view. Always ensure the engine is cool and be cautious when working around oil and engine components.
Where is the cam sensor located on a 94 Oldsmobile ciera cutlass s?
The 1994 Oldsmobile Cutlass cam sensor is located on the back of the left cylinder head. The cam sensor should be labeled as such.
