answersLogoWhite

0

What else can I help you with?

Related Questions

Which subnet mask should be used for a class B network that is divided into subnets that will accommodate between 800 hosts and 1000 hosts?

255.255.252.0


Which subnet mask should be used for a Class B network that is divided into subnets and will accommodate between 800 hosts and 1000 hosts?

255.255.252.0


What is the speed of a 1000baseT network?

1gbs that's what 1000 means


What is the maximum length of a 1000 ft Ethernet cable that can be used for network connections?

The maximum length of a 1000 ft Ethernet cable for network connections is 328 feet.


How many people in the 3rd class?

1000


Corporate address for Dish network?

Well, honey, if you want to reach out to Dish Network's corporate headquarters, you can send your love letters and complaints to 9601 S Meridian Blvd, Englewood, CO 80112. Just make sure to address it to the bigwigs over there and maybe they'll actually listen to what you have to say. Good luck, sweetie!


What is a NIC?

A network card, network adapter, network interface card or NIC is a piece of computer hardware designed to allow computers to communicate over a computer network. It is an OSI model layer 2 item because it has a MAC address. Every network card has a unique 48-bit serial number called a MAC address, which is written to ROM carried on the card. Every computer on a network must have a card with a unique MAC address. The IEEE is responsible for assigning MAC addresses to the vendors of network interface cards. No two cards ever manufactured should share the same address. Whereas network cards used to be expansion cards to plug into a computer bus, most newer computers have a network interface built into the motherboard A separate network card is not required unless multiple interfaces are needed or some other type of network is used. The card implements the electronic circuitry required to communicate using a specific physical layer and data link layer standard such as ethernet or token ring. This provides a base for a full network protocol stack, allowing communication among small groups of computers on the same LAN and large-scale network communications through routable protocols, such as IP. There are four techniques used for transfer of data, the NIC may use one or more of these techniques. * Polling is where the microprocessor examines the status of the peripheral under program control. * Programmed I/O is where the microprocessor alerts the designated peripheral by applying its address to the system's address bus. * Interrupt-driven I/O is where the peripheral alerts the microprocessor that its ready to transfer data. * DMA is where the intelligent peripheral assumes control of the system bus to access memory directly. This removes load from the CPU but requires a separate processor on the card. A network card typically has a twisted pair, BNC, or AUI socket where the network cable is connected, and a few LEDs to inform the user of whether the network is active, and whether or not there is data being transmitted on it. The Network Cards are typically available in 10/100/1000 Mbit/s. This means they can support a transfer rate of 10 or 100 or 1000 Mbit/s.


How many people were in 1st class titanic?

1000


What is the difference between business class and first class?

Depending on the airline...could be $400 to $1000


George ran 1000 yd in gym class how many kilometers did he run?

0.9144 kilometers in 1000 yards.


How did the world economic network of 1750 compare with that of 1000?

The economic network of 1000 was feudal agriculturalism, where the higher class would bestow power to those who would work for them as a fighter or farmer.. Starting in 1750, the economy became more industrialized and urbanized. Ne technologies, ideas and needs set forth in motion the Industrial Revolution in the 18th century. In 1000, the civilizations were more concerned with expansion geographically and survival through harsh conditions while in 1750, it was all about improving what they have and how to get it to the other side of the world to sell.


How much did it cost to rent rooms on the Titanic?

the rooms cost 30$ for third class and about 1000$for first class not sure about second class