0
Which command can an administrator execute to determine what interface a router will use to reach remote networks?
An administrator can use the show ip route command on a router to determine the interfaces that will be used to reach remote networks. This command displays the router's routing table, listing available routes, their metrics, and the corresponding outbound interfaces. By examining this information, the administrator can identify the interface associated with specific remote networks.
What else can I help you with?
What are the two levels of access using a command line interface?
1. administrator 2. standard
An administrator enters the show ip route command into a router What type of information will be displayed?
the networks learned from other neighbors
What is netstat used for in terms of computing?
Netstat is a command-line tool that displays network connections and a number of network interface and network protocol statistics. It is used to find problems on networks and determine how traffic effects performance.
Which command does the network administrator use to determine whether inter-V LAN communication is functioning?
Ping
What command could be issued to determine if the router has experienced any input or output errors?
show interface
What does the passive-interface command do?
Passive-interface command is used in all routing protocols to disable sending updates out from a specific interface.
What is 3 differences between software interface and command line interface?
Differentiate between Command line interface and Menus interface and example of each interaction style
What are two reasons for the absence of R1 in the output?
Refer to the exhibit. A network administrator successfully pings R1 from R3. Next, the administrator runs the show cdp neighbors command on R3. The output of this command is displayed.What are two reasons for the absence of R1 in the output? (Choose two.)~**The no cdp run command has been run at R1.**The no cdp enable command has been run at Fa0/1 interface of R3.R1 is powered off.
What interface is an interface that uses graphics as compared to a command-driven interface?
Graphical User Interface
What is the command to determine if interface Ethernet 0 is active?
Run "ipconfig".. If your Ethernet will be active it will show you the current IP address of NIC..
Which command would an administrator use to identify all hops between two nodes?
An administrator can use the traceroute command (or tracert on Windows systems) to identify all hops between two nodes. This command sends packets to the destination and reports back the IP addresses of the routers that handle the packets along the route. By analyzing the output, the administrator can determine the path taken and the response times for each hop.
What is a command line interface and graphical user interface?
Xyte/185.1838xyte
