0
What else can I help you with?
What is the command to copy nvram to tftp?
To copy the contents of NVRAM to a TFTP server on a Cisco device, you can use the command: copy nvram tftp After executing this command, you will be prompted to enter the TFTP server's IP address and the filename for the backup. Make sure that the TFTP server is reachable and properly configured to accept the transfer.
Which two pieces of information can an administrator verify by using the show version command?
contents of the nvram and the operating system version
What dos command display the contents of a directory?
DOSEXAFTERBREAKFAST
Which router component will have contents erased when the command erase startup-config is issued?
It cancels only configurations settings, such as securuty, DHCP ip range, static ip settings and so on...
What is the effect of using th Router copy running-config startup-config command on the router?
This is an incomplete command. However, this indicates that the running configuration will be saved on the device to a different location.
Which memory contents will change as a result of using the Router?
NVRAM
Which memory contents will change as a result using the router?
NVRAM
Which memory contents will change as the result of using the router?
NVRAM
What command displays the configuration stored in NVRAM?
wr or copy running-config startup config
Explain All the Internal Command of DOS?
DIR :- DIR is used to display the contents of a drive or directory.
Does finger display the contents of your plan file?
The finger command is used to display information about users on a system, including their login status and some personal details, but it does not directly display the contents of a plan file. However, if a user has a plan file (typically named .plan in their home directory), the finger command may show a brief excerpt from it in the output. To view the full contents of a plan file, you would need to use a command like cat ~/.plan.
what Recovery Console command shows the contents of an ASCII text file?
In the Recovery Console, the command to display the contents of an ASCII text file is type. You can use it by typing type <filename>, where <filename> is the path to the text file you want to view. This command outputs the text file's contents directly to the console screen.
