answersLogoWhite

0

What else can I help you with?

Related Questions

What is the command to copy nvram to tftp?

To copy the contents of NVRAM to a TFTP server on a Cisco device, you can use the command: copy nvram tftp After executing this command, you will be prompted to enter the TFTP server's IP address and the filename for the backup. Make sure that the TFTP server is reachable and properly configured to accept the transfer.


What command displays the configuration stored in NVRAM?

wr or copy running-config startup config


When a router boots what is the default order to locate the Cisco IOS if there is no boot system command?

flash, NVRAM, TFTP server


What is the consequence of issuing the erase startup-config command in privileged EXEC mode on a Cisco router?

Data Stored in the NVRAM will be erased


What do the commands for the Cisco switch IOS allow the user to do?

The Cisco IOS commands allow the user to enter partial Cisco IOS commands. If you start to type in a command it can recognize it and finish the command for you.


In a Cisco IOS device where is the start-up configuration file stored?

NVRAM


Which is the correct fallback sequence for loading the cisco ios?

flash,nvram,ram


What does the NVRAM in a Cisco switch store?

NVRAM is an acronym for Non-Volatile Random Access Memory. NVRAM is a type of Random Access Memory (RAM) that retains its information when power is turned off. The NVRAM is a small 24 pin DIP (Dual Inline Package) integrated circuit chip and is thus able to obtain the power needed to keep it running from the CMOS battery installed in your motherboard. It keeps track of various system parameters such as serial number, Ethernet MAC (Media Access Control) address, HOSTID, date of manufacture, etc. NVRAM is therefore a type of non-volatile memory that offers random access SYED OWAIS ALI{TECHNICAL SPECALIST}


What is setup mode?

When a Cisco router is booted up for the first time, or is reloaded, the router will look into its Non-Volatile RAM (NVRAM) for the startup configuration file. Setup Mode is usedto configure a Cisco router or switch after start up to create a startup configuration file.


How many VLANs can be configured on a Cisco 2960 Switch?

The command "show vtp status" will show you how many vlans are supported by the switch. The Cisco 2950 switch supports up to 64 VLANs.


In a Cisco IOS device where is the startup-configuration file stored?

NVRAM Stores startup-config. The IOS (Internetwork Operating System) is stored in the flash. Both flash and NVRAM are non volatile storages but there is a major difference.


What is the command line interface used for on a cisco router?

Cisco IOS uses a command line interface (CLI) for inputting commands when configuring Cisco Routers