0
On a Cisco switch, NVRAM (Non-Volatile Random Access Memory) is typically located within the switch's internal storage. It is used to store the startup configuration file, which is loaded when the switch boots up. You can access and manage the contents of NVRAM through the command-line interface (CLI) using commands like show startup-config and copy running-config startup-config.
What else can I help you with?
In a Cisco IOS device where is the start-up configuration file stored?
NVRAM
Which is the correct fallback sequence for loading the cisco ios?
flash,nvram,ram
What is setup mode?
When a Cisco router is booted up for the first time, or is reloaded, the router will look into its Non-Volatile RAM (NVRAM) for the startup configuration file. Setup Mode is usedto configure a Cisco router or switch after start up to create a startup configuration file.
What command displays the configuration stored in NVRAM?
wr or copy running-config startup config
What does the NVRAM in a Cisco switch store?
NVRAM is an acronym for Non-Volatile Random Access Memory. NVRAM is a type of Random Access Memory (RAM) that retains its information when power is turned off. The NVRAM is a small 24 pin DIP (Dual Inline Package) integrated circuit chip and is thus able to obtain the power needed to keep it running from the CMOS battery installed in your motherboard. It keeps track of various system parameters such as serial number, Ethernet MAC (Media Access Control) address, HOSTID, date of manufacture, etc. NVRAM is therefore a type of non-volatile memory that offers random access SYED OWAIS ALI{TECHNICAL SPECALIST}
What is the function of an NVRAM in a router?
The NVRAM is the primary place a router or switch stores the configuration file which tells the device how to operate.
Where is the information of a newly created VLAN stored on a switch?
NVRAM
When a router boots what is the default order to locate the Cisco IOS if there is no boot system command?
flash, NVRAM, TFTP server
In a Cisco IOS device where is the startup-configuration file stored?
NVRAM Stores startup-config. The IOS (Internetwork Operating System) is stored in the flash. Both flash and NVRAM are non volatile storages but there is a major difference.
What is the consequence of issuing the erase startup-config command in privileged EXEC mode on a Cisco router?
Data Stored in the NVRAM will be erased
Where do startup-config and a running-config reside in Cisco equipment?
startup-config resides in NVRAM and running-config resides in RAM.
What is the command to copy nvram to tftp?
To copy the contents of NVRAM to a TFTP server on a Cisco device, you can use the command: copy nvram tftp After executing this command, you will be prompted to enter the TFTP server's IP address and the filename for the backup. Make sure that the TFTP server is reachable and properly configured to accept the transfer.
