0
When assigning IDs to SCSI peripherals, ID 0 should generally not be used for devices other than the SCSI host controller itself. This is because ID 0 is typically reserved for the SCSI initiator, which is responsible for sending commands to other devices on the bus. Using ID 0 for other peripherals can lead to conflicts and communication issues within the SCSI chain. It's best to allocate IDs 1 through 6 or 7 for other devices, depending on the SCSI standard in use.
What else can I help you with?
What allows you to attach peripherals such as disk drives and printers?
scsi port
Allows you to attach peripherals such as disk drives and printers?
scsi port
High speed parallel port to attach peripherals like disk drives and printers?
SCSI port Special high-speed parallel port to which peripherals, such as disk drives and printers, can be attached.
What is you replace a customer's hdd with a single ended scsi system using approximately eight meters of cables in the scsi system after this installation the peripherals have stopped functioning wh?
the cable length is too long.
When you install a SCSI drive should it be set to a master or to slave?
Master and slave does not apply to scsi drives
Where do you terminate the SCSI chain?
To properly terminate a SCSI chain, you should place a terminator at the last device on the SCSI bus. This ensures that signals are correctly reflected and prevents data transmission errors. Depending on the SCSI type (like SCSI-1 or SCSI-2), the terminator can be a physical resistor pack or built into the device itself. Always check the SCSI specification for the specific requirements of your setup.
What is purpose of SCSI?
It connects eternal device, connects power supply to analyze data.-Small computer system interface.-for peripheral devices connectivity (8 devices (0-7))-Internal and external buses like power supply and extensive peripherals.-Ultra SCSI - 32 devices (no wire is required, all with is uses is wireless).-Physical drive accession - (Single hard dish is physical drive).-Logical drive accession.-SCSI ID is available in the device.Configuration done in booting.-5MB/Sec.-SCSI: 2--Fast SCSI - 10MB/Sec.--Wide SCSI - 16bit 20MB/Sec.-SCSI: 3--Support 32 device - 40MB/Sec.Note: the above answer is in the form of points.
What is the purpose of SCSI?
It connects eternal device, connects power supply to analyze data.-Small computer system interface.-for peripheral devices connectivity (8 devices (0-7))-Internal and external buses like power supply and extensive peripherals.-Ultra SCSI - 32 devices (no wire is required, all with is uses is wireless).-Physical drive accession - (Single hard dish is physical drive).-Logical drive accession.-SCSI ID is available in the device.Configuration done in booting.-5MB/Sec.-SCSI: 2--Fast SCSI - 10MB/Sec.--Wide SCSI - 16bit 20MB/Sec.-SCSI: 3--Support 32 device - 40MB/Sec.Note: the above answer is in the form of points.
How many devices can be daisy chained on a single standard SCSI controller?
Most modern SCSI buses support a total of 16 devices, while older SCSI implementations usually support only eight devices.
What scsi id should be assigned to a scsi-2 adapter card in a computer?
The host adapter is assigned SCSI ID 7, which has the highest priority over all other devices.
Which version of scsi is known as fast scsi?
SCSI-2
Which two SCSI connectors might be used with narrow SCSI?
DB25 SCSI connector50 pin SCSI connector
