0
What else can I help you with?
Which network topology requires the use of terminators?
The bus topology requires the use of terminators. In this topology, all devices are connected to a single central cable, known as the bus. Terminators are placed at both ends of the bus to prevent signal reflection, which can cause data collisions and network interference. Without terminators, the signals can bounce back along the bus, disrupting communication between devices.
How do you terminate a bus topology?
To terminate a bus topology, you need to install terminators at both ends of the main cable. These terminators absorb signals that reach the end of the cable, preventing reflections that can interfere with data transmission. Without proper termination, network performance can degrade due to these reflections, leading to data collisions and communication failures. Ensure that the terminators match the impedance of the cable used in the network to maintain signal integrity.
At the ends of each bus network are 50-ohm resistors known as?
terminators
A bus network would suffer from signal bounce without what?
a specific resistor/ capacitor circuit connected to a 555 timer will create a debounce switch in synchronous format
Who is terminators enemy?
Chuck Norris is terminators enemy
When was X-Terminators created?
X-Terminators was created in 1988.
Which type of network uses terminator and t-connector?
The type of network that uses terminators and T-connectors is the coaxial cable network, particularly in a bus topology. In this setup, T-connectors are used to connect devices to the main coaxial cable, while terminators are placed at both ends of the cable to prevent signal reflection and ensure signal integrity. This configuration was commonly utilized in early Ethernet networks.
When was The Terminators - film - created?
The Terminators - film - was created on 2009-04-28.
What are the proper requirements for a 10Base2 network?
The requirements for a 10Base2 network: RG58u Coaxial cable T-connectors BNC's Terminators Ground, usually a ground chain Internetworking with Cisco and Microsoft Technologies pg. 226 and 227
What is purpose of terminator on bus topology?
In a bus topology, the purpose of a terminator is to absorb signals at both ends of the bus cable, preventing them from bouncing back and causing network interference. Without terminators, signals could reflect back along the bus, leading to data collisions and communication errors. By ensuring proper signal termination, terminators help maintain the integrity of data transmission across the network.
What is the purpose of terminator in bus topology?
In a bus topology, the terminator serves to absorb signals at the ends of the bus, preventing them from bouncing back along the cable. This helps to eliminate reflections that can interfere with data transmission, ensuring that signals travel smoothly along the bus. Without terminators, data collisions and network errors can occur, leading to unreliable communication. Thus, terminators are essential for maintaining network integrity and performance.
What network topology has one central cable with terminators at each end?
The network topology that features one central cable with terminators at each end is known as a bus topology. In this configuration, all devices are connected to a single linear cable, known as the bus, which facilitates communication among them. This topology is relatively easy to set up and cost-effective for small networks, but it can suffer from collision issues and is less reliable than other topologies, as a failure in the central cable can disrupt the entire network.
