The fastest check is to see the green light on the back of the PC and whatever other device you are connected to. When you unplug the cable the green light should go out. That indicates that the device on your end is seeing power from the other end. If the light is not on there is either a faulty device or a cable problem. If the light is on at both ends, and goes off when you unplug the cable you probably have a good hardware connection. If the cable is correct, there is more to check. The most common error is that the two devices are not configured to talk to each other. This is most often caused by an error in the speed and duplex settings. If one device is set to 10 mb and the other is set to 100 mb they will not talk and you will see the disconnected status. The same is true if the duplex (full/half) are set incorrectly. You may also have incompatible network protocols.
because your cam is either not installed or connected
If you have an ethernet cable plug it into the modem and they should be connected. My Modem is connected with a router to the rest of the network and with the internet modem and is both wireless and wired
Receivers can be connected to the TV via a Coaxial cable. This allows the TV to use Ch. 3-4, or Ch. 60 or 73 for TV2, to show a picture rather than the input.
The PC has programs that show who is connected to your network. One came with the router I purchased and I could see what else was connected to my network.
you need to go into the properties for the wireless connection and check to box "show icon in notification are when connected". Also check taskbar properties- uncheck "hide inactive icons"
Go into the servant's entrance. Click to rotate the cables until the start cable is connected to the end cable. You will do this serveral times.
Go into the service entrance and click on the TV. The goal is to connect the start cable to the end cable. Rotate the pieces by clicking the mouse.
Measure the ground resistance from the user end point, where earth or ground cable is connected. It will show a very high resistance or open if ground is broken.
To display LG TV pictures on your screen, you can connect your LG TV to your screen using an HDMI cable. Simply plug one end of the HDMI cable into the HDMI port on your LG TV and the other end into the HDMI port on your screen. Then, switch the input on your screen to the HDMI port that you connected the cable to. This should allow you to see the pictures from your LG TV on your screen.
The Apple HDMI to HDMI cable lets you connect an Apple TV, Mac mini, There are a number of HDMI-standard cable connectors available, The thing is, when I use an RGB cable it works just fine, and I can get my laptop screen to show up on the TV
You have to contact to ur internet service provider http://bizvizadvertising.com
firstly click on the icon of network connection right bottom corner . it will show 2 options .1-connect or disconnect 2-network and sharing centre . click on connect or disconnect. from here u can easily operate your network connection.