answersLogoWhite

0

the output from a balanced modulator consists of modulating freq also. this can be eliminated in a diode modulator by adding two more diodes, making a diode ring. therefore called ring modulator

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Why balanced modulator is called balanced modulator?

the output from a balanced modulator consists of modulating freq also. this can be eliminated in a diode modulator by adding two more diodes, making a diode ring. therefore called ring modulator


How is balanced modulator different from diode bridge modulator?

A diode bridge modulator is one kind of balanced modulator.


What does a balanced modulator produce?

Please answerin the case of communication , a balanced modulator is used to suppress the carrier from a conventional amplitude modulated signal


AM-DSB-SC signal which detector is used?

WE CAN use the balanced modulator & also the double balanced modulator(DBM) THANKS. ASMA


What is a diode modulator?

A diode modulator is a type of AM modulator constructed using diodes. One type of diode modulator is the ring modulator shown in the image.


Could a balanced modulator be used as a synchronous detector?

yes


Is there a seal at the end of the vacuum modulator?

There should be an o-ring where the modulator is inserted into the transmission. There should be no fluid where the vacuum line attaches, if so the modulator is bad.


Block diagram of amplitude modulation?

The basic block diagram consists of a modulator which may be a product modulator or a balanced modulator. The audio input signal is fed to the input of the modulator and there it is being multiplied by the carrier signal which is generated by using a oscillator. This block diagram in its crude form is given by:


How do you replace the vacuum modulator on a 1967 mustang?

Jack up and support the rear of the car to minimize fluid loss. Remove vacuum hose from modulator. Remove bolt and retaining clip from under modulator. Remove modulator by pulling straight out. Install new modulator with new o-ring, replace clip and bolt and vacuum hose.


Which transistor is used in internal structure of LM 1496 balanced modulator demodulator IC?

A 2N3904 is the one in this package.


How do you remove the modulator on a 1967 Chevy truck?

Assuming this is a PowerGlide or Turbo-350 automatic transmission vacuum modulator, to minimize fluid loss jack up the rear of the truck and support with suitable jack stands, place a drip pan under the modulator, pull off the vacuum line from the modulator, remove the small bolt and clamp holding the modulator in place, gently twist and pull the modulator out taking care not to lose the small actuator pin inside. Keep the dirt from entering the opening. Install the new modulator with a new o-ring.


Where does the o-ring in the transmission go in a 2001 Ford F-150?

Usually the dip stick & modulator have o-rings.