answersLogoWhite

0

It is advantageous to detect defects in a particular phase to prevent problems in the next stages of the production. A single problem may compromise the whole production.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

Why flat organization most appropriate for bank?

It is advantageous to detect defects in a particular phase to prevent problems in the next stages of the production. A single problem may compromise the whole production.


What are the new phases introduced in Phase 10?

In Phase 10, the new phases introduced are Skip, Wild, and Color.


What are the mistakes faults caught during the same phase of sdlc called as?

defects


What is defect leakage?

Defect leakage formula is software testing metric to calculate the number of defects that went undetected to next phase(s). Defect leakage is a important metric that indicates the efficiency of process, test procedures, testing phases. Defect leakage can be calculated across different phases with in SDLC. However, Defect leakage is usually calculated for the number of defects that went undetected to production environment. Defect leakage is calculated as below Number of defects found in current phase that were supposed to be found in previous phase Defect leakage = ------------------------------------------------------------------------------------------------------------------------- X 100 Number of defects found in the previous phase e.g. If 40 defects were found during product testing and 5 defects were found in UAT and 2 in production environment then defect leakage % will be 17.5 % ((5+2)/40*100)


What is an HPLC column?

HPLC Column is one type of tube containing a stationary phase react with mobile phase to detect peak


What is Formula for residual defect density in QA?

The formula for residual defect density in QA is: Residual Defect Density = (Number of defects remaining after a phase / Size of the phase). It is used to measure the effectiveness of defect removal in a particular phase of the software development process.


What is utrasonic intruder alarm?

A signal usually 30khz to 40khz is send out and a receiver will detect this frequency. An intruder by merely disrupting this signal [phase shift as in Doppler effect] and cause the receiver to detect a phase shift and sound an alarm of sort.


Process in which an antigen is introduced to stimulate the immune system?

The DNA resistance phase or bacteriuom.


What techniques do people use in cubism?

In the first phase, oil painting. In the second phase (after 1912) they introduced collage.


Difference between line transformation ratio and transformation phase ratio?

line transformation ratio would be the turns ratio (ie voltage ratio), while the phase transformation ratio is most probably the phase shift introduced by a 3 phase transformer.


Does overload relay detect phase reversing of the 3 phase motor?

No, three phase motor overloads just monitor the motor's lines for an overload. Once detected the circuit holding the magnetic starter in will drop out and take the motor off line.


Why must the cell go through G2 phase?

To grow and detect problems.. Its Britt from vowles 2010 hope i helped you:]