0
A large number of accidents around the work place, are cause by
tripping over trailing wires
this is all I have got sorry
but i have a few ways that you can prevent it, this might help
How to prevent accidents from trailing wires: •Tuck in all wires, so there not near where everybody walks
•Use keyboards, mice that are wireless this would reduce the
amount of wires that are around the workplace, so it would reduce
the chance of someone getting injured of the wires being damaged.
•Spread the computers out so that there not all cramped together,
this would mean that there are not as many wires around the
workplace, which would reduce the chance of someone being
injured or the wires getting damaged.
What else can I help you with?
Where is the computer located on a 2000 ram van?
It should be located under the hood, on the firewall, near the center. It will have a lot of wires going to it.
Where are the wires on pylons?
Near the metering unit.
When outside what do you do during earthquake?
make sure your not near any electrical wires or telephone wires
When the signal from one pair of wires interfaces with the signal on another pair of wires?
Near end crosstalk
Who is more likely to be hurt a bird sitting on electricity wires or a boy flying a kite near the wires?
the bird
How many o2 sensors on a 2003 protege?
There are two. One near the top of the exhaust manifold and one on the exhaust pipe trailing from the manifold.
What things should not be taken near computer?
I dont think that leaving water, or small children near a computer is a good idea.
Why is water dangerous near a computer?
U see, when u throw water on a computer it has a very bad affect because the water goes to the wires and u should know that when electrical things are hit by water, they get ruined therefore the computer will get ruined and will stop working.
What is near by?
A computer, apparently.
What is near?
A computer, apparently.
What is a aileron?
AILERONS-Primary flight control surfaces mounted on the trailing edge of an airplane wing, near the tip. Ailerons control roll about the longitudinal axis.
Do rabbits chew wires and if so, how can I prevent them from doing so?
Yes, rabbits may chew wires. To prevent this behavior, you can protect wires with covers or tubing, provide plenty of chew toys for the rabbit, and supervise them when they are near wires.
