No. The windings are set for 9vdc and will not step down to 5vdc.
No.
Most of the mobile phones have batteries of less than 5V rating, mostly up to 3.7V.Chargers are typically rated for less than 5V.Caution: It is not safe to charge these with a 9V charger. The battery may explode..
A 5V 2A charger outputs 10 watts of power.
The power output of a 5V/2A charger is 10 watts.
yes
To modify the input voltage to match the desired output voltage. Say you need 5V to operate TTL technology and you only have a 9V battery. You build an SCC change it from 9V to 5V.
To modify the input voltage to match the desired output voltage. Say you need 5V to operate TTL technology and you only have a 9V battery. You build an SCC change it from 9V to 5V.
No the voltage gap is too wide. If the higher voltage is used there is the possibility that the connected device might be destroyed.
No. In general, a charger needs to be able to figure out when the battery has reached full charge, otherwise the charger can damage the battery by overcharging it. You need to use the specific charger required for the battery. And, if you are trying to power a non-battery device that requires 1A from a 5V 100mA source, you will not be able to maintain 5V, so it will not work there either.
That's almost twice the voltage. The chances of frying your device is high.
No. Usually it's a -/+ 10% difference. So, a 9v would need at least 7.2 volts or more
It depends on the load. If there is no load, it will only draw the regulator's quiescent current, specified on the datasheet.