To change the cord in a Weed Eater RT112, first, ensure the trimmer is unplugged or the battery is removed for safety. Remove the spool from the trimmer head by pressing the tabs and pulling it out. Then, take the new line, cut it to the desired length (usually about 10-12 feet), and insert it into the spool, winding it in the correct direction. Finally, reassemble the spool back into the trimmer head and ensure it’s securely in place before use.
The best way to replace a weed eater cord is to first make sure the engine is off and cool. Then, remove the spark plug wire to prevent accidental starts. Next, remove the spool housing and old cord. Install the new cord by winding it onto the spool in the correct direction. Finally, reassemble the weed eater and test the cord before using it.
http://lawnandgarden.manualsonline.com/manuals/mfg/weed_eater/545117526.html?idRes=15826863 This link should let you obtain the manual for detailed instructions with photos.
No, electric weedeaters have a motor and a cord spool.
One reason that the pull cord on a Weed Eater Blower may have become stuck is because the spring broke. You can try to take it apart to fix it, but it can be difficult. The best option is to bring it into a repair shop.
You can get rid of an old weed eater at a recycling center. If you take the weed eater apart, you can get money for the metal.
Mister Weed-Eater was created in 1993.
In general- secure a replacement starter cord. Remove the cord starter reel, Wind the spring driven reel about 5 turns, aligning the cord hole in the reel with the channel for the cord. While holding the reel against the spring, insert the starter cord, tie a knot on the cord inside the reel, let the spring gradually turn the reel until the cord Is wrapped on the reel, replace the starter wheel unit on the weed eater, replace the screws that hold it in place.
I can't seem to get the spool off.
weed whacker
What type of oil does weed eater or7000
the correct name is weed whacker, weed eater is only used by people down south...the more common name is weed whacker because it is the tools name whereas weed eater is only a brand name and not the official name of the tool
Changing the oil is as simple as looking for the oil gauge on the weed eater. Once one finds the gauge within the weed eater, then remove the cap and remove the oil.