To remove the battery from a 2004 Oldsmobile Silhouette, first ensure the vehicle is turned off and parked on a level surface. Open the hood and locate the battery; then, using a wrench, disconnect the negative (-) terminal first, followed by the positive (+) terminal. Remove any securing brackets or clamps, and carefully lift the battery out of its tray. Always handle the battery with caution due to its weight and potential acid exposure.
VERY CAREFULLY !
To change the thermostat in a 2004 Oldsmobile Silhouette van, first ensure the engine is cool and disconnect the negative battery cable. Drain the coolant from the radiator and remove the upper radiator hose to access the thermostat housing. Unbolt the thermostat housing, remove the old thermostat, and clean the mating surfaces before installing the new thermostat with a new gasket. Reassemble everything, refill the coolant, and reconnect the battery.
To replace the shift solenoid in a 2004 Oldsmobile Silhouette transmission, first disconnect the battery and remove the transmission pan to access the solenoid. Locate the shift solenoid, typically found on the valve body, and disconnect the electrical connector and any retaining clips. Remove the old solenoid and install the new one, ensuring it is securely fastened. Finally, reassemble the transmission pan, refill with fluid, and reconnect the battery.
To remove the radio faceplate in a 2004 Oldsmobile Silhouette Premier, start by using a flathead screwdriver or a trim removal tool to gently pry off the plastic trim surrounding the radio. Once the trim is removed, you can access the screws securing the radio unit. Unscrew these screws, then pull the radio out carefully to disconnect the wiring harness at the back. Make sure to handle all components gently to avoid damage.
battery removal of 2004 harley dyna
On the driver side you have to remove the tire to get to the battery.
Push the odometer trip reset till you get to "oil" then press and hold down till it reads "100"
You can find the 2004 Oldsmobile blend door behind the passenger side kick plate. Remove the kick plate to access the blending door.
remove battery cable
Remove the seat. You will find the battery under it. Remove the negative terminal first, then the positive terminal.
Remove the seat.
Remove the driver side front wheel then remove plastic skirting. Battery is on a shelf forward of wheel.