There are many possible reasons. You would need to provide some more detail on the vehicle (Year) and is the remote start "Factory" installed? Do the exterior lights on the vehicle flash when the remote start is activated? Is the "Check/Service engine" light on? The more info the better.....
To control remote control can lights in your home, you can use a compatible remote control device that is specifically designed for the lights. Simply point the remote at the lights and press the appropriate buttons to turn them on or off, adjust the brightness, or change the color if they are color-changing lights. Make sure the remote control and the lights are within range for proper functionality.
You can buy a remote control to work on the lights of your choice at LOWES HOME IMPROVEMENT CENTER in the lighting department.
check if your lights are still on that drained the battery
To operate remote control ceiling lights efficiently and effectively in your home, familiarize yourself with the remote control functions, position the remote within range of the lights, and use the appropriate buttons to turn the lights on/off, adjust brightness, and set timers or schedules for automated lighting.
You can get a voice activated remote control which will work with most modern TV's. Look for stores that specialize in 'low vision' products.
If the electronic locks work by the buttons in the car , its probably the remote . The remotes have to activated by accessing the cars onboard computor.
A sensor that is activated by a lack of light (the dark). Usually these can be found in night lights that turn on when the lights are turned out.
One can find remote control lights from The Internet Electrical Store, Zapmeta, eBay, RC Lighting, Home Depot and Argos stores. Remote control lights are spotlights on high ceilings that anyone can use remote control the spotlights from floor level without the use of ladders.
If the lights are not working after using the remote start on a 2003 F-250, then something is wrong with the way it was wired when the remote start was installed. The remote start has wires to hook up to the lights so that a person knows the vehicle started. Perhaps this step was skipped in installation.
The remote, or "key fob", has to be activated at the dealership for your specific car, otherwise it will not properly interact with the computer in the car.
This depends on if the emergency signal lights are activated. It should be noted that even with emergency lights and sirens activated, ambulances are not allowed to exceed the speed limits. That said, if the ambulance has a patient in it, but the lights and sirens are not activated, a regular motorist can pass the vehicle but is discouraged from doing so. NO! If you pass it, other people might and the patient might be affected.