answersLogoWhite

0

When there is only one hard drive (disk) in the computer, the jumper(s) on the back of the disk (next to the power socket) should be set to Master or Stand Alone. When there are two disks, one must be designed Master & the other Slave or the system will not boot or only one disk will be seen.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

IDE and EIDE hard drives are usually set to be in what configuration by default?

Single drive


What drawback does a single firewall configuration have this is corrected by a two firewall configuration?

Single point of failure


What are Hard Drive Configuration?

Hard Drive configuration is used to define the Slave and master Hard Drive. When we are attaching more than one hard drive the configuration is used. Configuration is done by jumper setting which is available in back side of hard drive...1st two pins for master hard drive and last pins are slave..


If a hard drive has slave-drive configuration it is probably?

The second drive.....


What are various configurations of differential amplifiers?

Dual input and Balanced output configuration, Dual input and Unbalanced output configuration, Single input and Balanced output configuration and Single input and Unbalanced output configuration


What is hard drive configuration and controllers?

The hard drive controllers are SATA, IDE, and EIDE. The hard drive configuration tells the computer what drive controller to use and how to store the information and where to store the information.


In what incorrect drive configuration?

In a Windows operating system, an incorrect drive configuration usually indicates a physical error. The error could be part of the drive itself or in the actual mechanism.


How many passengers can he Boeing 777-200 ER Carry in a single configuration?

In a single-class configuration, the Boeing 777-200ER has a capacity of 440 passengers.


What is the height of a single unit in a rack configuration?

1.75


What are Hard Drive Configuration and Controllers?

dont knowufeufgueeufheikw,nfiuef


Can you run UDK on a expansion drive?

with proper configuration it is possible.


What type of drive uses master and slave connections?

The type of drive that uses master and slave connections is the IDE (Integrated Drive Electronics) drive, also known as PATA (Parallel ATA). In this configuration, two drives can be connected to a single IDE channel, with one designated as the "master" and the other as the "slave." This setup allows for efficient data transfer between the drives and the motherboard. However, this technology has largely been replaced by SATA (Serial ATA) drives, which do not use the master/slave configuration.