answersLogoWhite

0

There are no brass caps on any of the numerous batteries I have seen.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

How do you take a cap off of a sewer clean out?

Depends if it is a cap or a plug or no hub or a brass /lead plug


Can a 1500 mAh battery replace a 1600 mAh battery?

Yup......But only if u connect them in PARALLEL! Connecting them in parallel (e.g. the positive cap from Battery 1 is connected with the positive cap from battery 2.....the negative cap from battery 1 goes with negative cap from battery 2) adds the amperage (voltage remains the same).......Connecting them in SERIES (as in any flashlight the positive cap of battery 1 goes with the negative cap of battery 2 making a "bigger battery" that has the positive cap from battery 2 and negative cap from battery 1...) adds the voltage (the amperage is the same). Note: Use same batteries either parallel or series connection.


What side does the brass go on a garrison cap?

it goes on the left side as if someone is loking at you. or on the side that doesnt have the little fold on it.


Where is the inlet for the windshield washer fluid on a 2001 Suburban?

The filler cap in in front of the battery. The actual container in under the battery, but the cap can be found right in front of the battery.


Center electrode post of ordinary flashlight battery?

Brass


Can you use copper and brass together on battery terminal?

Yes


What does a Cap booster battery cost?

50p


How do I change the battery on an LLBean cap?

To change the battery on an L.L.Bean cap with a built-in LED light, first, locate the battery compartment, usually found on the inside of the cap. Use a small screwdriver to open the compartment and carefully remove the old battery. Insert a new battery, ensuring the positive and negative ends are aligned correctly, then close the compartment securely. Make sure to test the light to confirm the battery has been replaced successfully.


How can you make a Remington 1187 Sportsman shoot low brass ammo?

On the end of the magazine tube is a rotating cap marked "L" & "H".The "H" stands for high "brass" loads,the "L" for low "brass" loads. Ed


What is the material used for Edison screw cap?

Usually brass plated with nickel. Aluminium is also used.


What are the uses of metal cap in a battery?

it goes up in flames


What uniform would a World War 2 RAF sargent wear headgear wise?

While off duty, he would wear a side cap which is very similar to the US "overseas cap", except it had a piece in front that had 2 brass buttons. It was BLUE and usually had a brass cap badge on the Left side which was the initials RAF surrounded by a wreath.