6 tablespoons.
No much, just sprinkle it on the spill.
In a lead acid battery, the limiting reactant is typically the sulfuric acid (H2SO4) electrolyte. This is because the sulfuric acid provides the ions needed for the electrochemical reactions to occur at the electrodes. If there is not enough sulfuric acid present, the battery's performance can be limited.
To neutralize sulfuric acid with pH 3, you will need to calculate the amount of lime milk required based on its alkalinity. Lime milk typically contains calcium hydroxide, so you should determine the concentration of calcium hydroxide in the lime milk and use stoichiometry to find the quantity needed to neutralize the sulfuric acid. It's important to also consider the reaction stoichiometry and ensure that all acid is neutralized for a complete reaction.
To effectively remove acid from tomato sauce, you can add a pinch of baking soda to neutralize the acidity. Stir well and taste to adjust the flavor as needed.
well, the battery is in the trunk. you need to remove the strap that holds the battery in, after, remove the negative then the positive terminal. wah-la! its out :D reverse to put it back. if needed, clean with baking soda.
sulfur
To safely dispose of muriatic acid using baking soda, slowly add baking soda to the acid in a well-ventilated area. Stir the mixture until it stops fizzing, then neutralize it with more baking soda if needed. Once neutralized, you can safely dispose of the mixture down the drain with plenty of water. Be sure to wear protective gear and follow proper safety precautions.
1200
The balanced chemical equation for the reaction is 1 mol of sulfuric acid reacts with 2 mol of ammonium hydroxide. Therefore, for 8 mol of ammonium hydroxide, 4 mol of sulfuric acid are needed. To calculate the grams of sulfuric acid needed, you would multiply the number of moles by the molar mass of sulfuric acid.
You can substitute baking powder for baking soda in a recipe, but the amount needed may vary.
the main thing is to keep the battery charged and check the water level in the battery..also clean the outside of the battery with baking soda and water as some cleaning fluids can be too abrasive.Keep an eye on the tyre pressure too.Spray wd40 periodically around all joints.
Approximately 1.31 grams of boric acid is needed to neutralize 1 gram of caustic soda.