0
What else can I help you with?
How do I remove a metal carpet threshold that has no screws or nails to install a wider threshold to cover where the cat frayed the carpet?
You probably have the kind that clamps down on the edge of the carpet. It started out as a V. the bottom part is nailed down, the edge of the carpet is inserted and the top half clamped down to hold it. There are hooks on the bottom half that grab the carpet. To remove it, pry up the top half, hold back the carpet and pull up the strip.
How do you grind around corners on cart surfer on club penguin?
you hold down the down arrow key and the way your supposed to go
What is a carpet nail?
In the industry, a carpet nail could be one of three things. #1 A reference to the tacks that used to be used to hold down carpet on a wood floor prior to tackless strip ( the 1" wide pieces of wood with pins on it around your walls). Or #2 A nail to hold down those 1" pieces of wood. Or #3 One of the sharp pins in the 1" pieces of tackless strip that hold the carpet onto the tackstrip. There is also a reference to " stay nails " in the industry. These are 1" concrete nails that are driven into the carpet to aid in the installation process and then removed when the installation is complete.
How do you remove the airbag sensor on a 1998 Pontiac grand am?
First you have to remove the passenger side seat. Then remove the hold down screws and molding that is along the door sill holding down the carpet. Then very carefully lift up the carpet and the air bag sensor should be there. Then remove the three screws that hold the sensor in and unplug it.
What tools do you need to install carpet?
To install a carpet you would need to make sure you have the proper equipment. You will need a tape measure, seam tape to connect multiple pieces of carpet together, a putty knife to push the carpet under the baseboards of a room (if it has baseboards), a power stretcher to ensure your carpet remains tight and does not wrinkle, a carpet pad and glue to keep the carpet off your floor directly and make it feel softer, carpet cutters to trim away excess carpet and a tack strip around the perimeter of your ROM to hold the carpet down.
How do you get predictive text on a samsung g600?
Hold down the * key when you are in the text area.
How do you take out the rear seat in a 1994 Nissan altima?
Two bolts on the front corners of the bottom half of the seat, hold it down. The top half is held down by two bolts that are under the bottom half.
What is the purpose of a carpet tack and how is it used in carpet installation?
A carpet tack is a small nail-like object used to secure carpet to the floor. It is used in carpet installation to hold the carpet in place and prevent it from shifting or moving. The carpet tack is hammered into the floor along the edges of the carpet, allowing the carpet to be stretched and secured tightly in place.
How can you ensure the canopy hold down is secure during windy conditions?
To ensure the canopy hold down is secure during windy conditions, use heavy-duty stakes or weights to anchor the corners of the canopy to the ground. Additionally, consider using tie-down straps or ropes to further secure the canopy to nearby structures or objects. Regularly check and tighten the hold down mechanisms to prevent any loosening due to wind.
Where is the transmission computer on a 92 Honda Accord Ex?
Answer:It's located on the front passenger cowl/floorboard, behind a panel, under the carpet. Remove the passenger kick panel, sill cover, and peel back the carpet. Remove the 10mm bolts that hold the cover down, remove the 10mm bolts that hold the computer to the backside of the panel.
How long will Berber carpet hold up?
Berber carpet should hold up for at least 7 years. Make sure you have it installed properly. If you do this, it should last a lifetime. Good luck!!
Fuel pump shut off 2003 ford ranger?
its on the passenger side firewall. pull back the carpet and with the ignition on, hold the switch down for 3-5 seconds.
