0
What else can I help you with?
How do you connect your art tube mp studio mic preamp to your laptop and if i have a preamp do i need a mixer too for my home studio?
Yes it is just a preamp you need an audio interface that will connect the preamp to the audio interface into the computer and obviously a Mic in front of it
I'm a noob to recording so if have a 9-track mixing board do I need a preamp to run a condenser microphone?
A preamp is required for all microphones, and is built in to the mixer if it accepts microphone inputs. The feature required for most condenser microphones is phantom power, a 48 volt signal that is supplied by the mixer to power the electronics inside the microphone. You must use an XLR (three pin) cable to connect the mic to the mixer to provide this power. There will be a Phantom or 48V switch on the mixer to turn this feature on and off.
Will a mixer allow you to hook up your microphone to your laptop via usb and if so which cheap mixer is good?
What you need is an USB recording interface with a microphone preamp (like M-Audio Fast Track), they usually cost $100 and up.
What are the key features to consider when choosing a computer mic mixer for optimal audio performance?
When choosing a computer mic mixer for optimal audio performance, consider features like the number of input channels, preamp quality, phantom power for condenser mics, built-in effects, and compatibility with your recording software.
What is the device used to improve signal-to-noise ratio called?
A preamp A preamp.
Where can I find a good preamp to purchase?
There are many places online to buy a preamp. Amazon sell a range of preamp products including ultra compact preamps. The site Preamp also stocks a wide range of preamps.
How do you test the output of an acoustic guitar preamp?
To test the output of an acoustic guitar preamp you may use output tubes to test. This will test the preamp voltage.
What could be the reason why my acoustic guitar preamp is not working?
There could be several reasons why your acoustic guitar preamp is not working, such as a dead battery, loose connections, or a faulty preamp unit.
Could a phono drive be used as an amplifier for a mixing desk?
It's not clear what you mean by "phono drive". If you are asking about using a phono preamp as a microphone or instrument preamp and sending the output of the preamp to the mixer, you will find that the phono preamp has two problems:First, it does not have anything close to flat frequency response. Phono preamps are designed with a strong equalization curve, which compensates for the EQ that is used when high-fidelity recordings are mastered. You will get lots of bass and no highs if you try to run a mic or instrument signal through a phono preamp.Second, you may find that it does not have a lot of headroom. A phono preamp is sensitive and a microphone or instrument could drive it into saturation.For the same reasons, you certainly cannot use a phono preamp as a line-level amplifier in a mixer.If you happen to be asking if you can use a Mod Squad or McCormack Phono Drive as a preamp for a turntable and run the output of the Phono Drive (as line level) into a DJ mixing desk, then the answer is yes, that should work quite nicely (even though the Phono Drive is, in my opinion, an absurdly overpriced piece of gear).
What are the benefits of using a Fishman preamp with an acoustic guitar?
Using a Fishman preamp with an acoustic guitar can enhance the sound quality by providing better control over the tone and volume. It can also help reduce feedback and make it easier to connect to amplifiers or sound systems for performances.
What is phantom power and what are its uses?
Phantom power is 48VDC power applied by a mixer or preamp or other piece of gear to power a condenser microphone or Direct Inject (DI) box attached to it. It can coexist with the microphone signal, and dynamic microphones generally will ignore it and not be hurt by it.
How do you rebuild a 1985 Corvette preamp?
I
