In short, Drip Pot is being used in Coke Oven Gas piping mainly for removing the condensate generated in the pipe line due to condensation of vapour mixed in the Coke Oven gas which is basically a mix gas. The Drip Pot facilitate removal of condensate from Pipe Line without increasing hazard of excessive gas release from gas line which in tern reduces the risk of inhalation of toxic gas by the operator or the nearby people.
The purpose of a drip leg in the gas piping is used as a device to capture dirt and debris from entering the furnace.
Galvanized piping or painted depending on local codes and type of fuel (gas) NO drip legs where the piping is subject to freeze ups
Hydrogen gas 55%
Piping material used for forming gas would be 316L stainless steel.
2.0%CO2, 5.5%CO, 32%CH4, 51.9%H2 , 0.3O2 and 4.8%N2
form_title=Gas Piping Installation form_header=8883 How would you best describe the scope of the work? (Select all that apply)*= [] Repair leak in gas line [] Replace old gas lines [] Appliance gas hook-up [] Supply gas line to appliance(s) in or near the home [] Supply new gas piping from the street to the home [] Other Which of your appliances need gas?*= [] Fireplace [] Barbecue [] Clothes Dryer [] Stove/oven/cooktop [] Central heating system [] Water heater [] Generator [] Other
To get the electricity from where it came from to where it is going, Just like water piping, gas piping, sewer piping, etc.
Steam pipes? cant do with out drip legs, Waste line NG either, Vent lines nope cannot do it either or with gas thus one should know WHAT the piping is for
the coke factory
Gas piping must be bond to the appliance it serves.
The gas valve in an oven controls the flow of gas to the burner, regulating the temperature inside the oven for cooking or baking.
Most codes do not allow Galvanized piping/fittings on gas piping. I have used galvanized pipe/fittings on exterior gas piping before in the state of Michigan but other states do not allows this. Check with your local code authorities.