No. Carbon monoxide is a by-product of the burning of gas. If the gas isn't burning, no carbon monoxide is being produced. However, you should be aware of escaping gas and shut-off the gas supply to any malfunctioning equipment. Gas boilers should be regularly serviced, and only serviced by suitably qualified technicians.
To determine if the water heater pilot light is out, locate the pilot light access panel on the water heater. Look inside to see if the pilot light is lit. If it is not lit, you may need to relight it following the manufacturer's instructions.
To light a gas heater with an electronic pilot, locate the pilot light button on the heater. Press and hold the button while simultaneously pressing the ignition button. Keep holding the pilot button for about 30 seconds to allow the pilot light to ignite. Release the pilot button and adjust the temperature as needed.
Have you turned the control from Pilot to On? Have you increased the temperature setting?
The heater pilot light may not stay lit due to issues with the thermocouple, gas supply, or a dirty pilot light. It is important to check and clean these components to ensure the pilot light stays lit.
The pilot light on the water heater went out because there was a lack of gas flow or a problem with the ignition system.
To properly light a gas heater for optimal performance and safety, follow these steps: Make sure the gas supply is turned off before starting. Locate the pilot light and follow the manufacturer's instructions to ignite it. Once the pilot light is lit, turn the gas supply back on and adjust the temperature settings as needed. Regularly check for any gas leaks or unusual smells and immediately turn off the heater if detected. Keep the area around the heater clear of any flammable materials and ensure proper ventilation to prevent carbon monoxide buildup.
If the pilot light is on, the heater should come on by itself. If the pilot light is off then it has to be lit. If it will not stay on, the thermocouple is bad.
To turn on the water heater pilot, locate the pilot light button or knob on the water heater. Turn the knob to the "pilot" setting and hold it down. While holding the knob down, use a long lighter to ignite the pilot light. Once the pilot light is lit, continue holding the knob down for about a minute before releasing it. This should successfully turn on the water heater pilot.
To turn on the pilot light for your water heater, locate the pilot light assembly near the bottom of the water heater. Turn the gas control knob to the "pilot" setting and hold it down. While holding the knob down, use a long lighter to ignite the pilot light. Once the pilot light is lit, continue holding the knob down for about 30 seconds before releasing it. If the pilot light stays lit, turn the gas control knob to the "on" position to start the water heater.
To relight the water heater pilot, locate the pilot light button or knob on the water heater. Turn it to the "pilot" setting and hold it down. While holding the button down, use a long lighter to ignite the pilot light. Keep holding the button for about a minute after the pilot light is lit to ensure it stays on. If the pilot light continues to go out, there may be an issue with the thermocouple that needs to be addressed by a professional.
The gas water heater pilot light may not stay lit due to a faulty thermocouple, a clogged pilot orifice, insufficient gas flow, or a draft near the pilot light.
The water heater pilot light may not stay lit due to issues with the thermocouple, gas supply, or ventilation. These problems can prevent the pilot light from staying lit, leading to the water heater not functioning properly.