0
What is the distance required between a Direct Vent Furnace Exhaust and a Dryer Exhaust?
The required distance between a direct vent furnace exhaust and a dryer exhaust typically varies by local building codes and manufacturer specifications. However, a common guideline suggests maintaining at least 3 feet of separation to prevent potential interference from exhaust gases. Always consult local codes and the specific installation manuals for both appliances to ensure compliance and safety.
What else can I help you with?
Why electric arc furnace shell to be grounded?
Which is the mínimum distance between the electrode an a grounding part.
What is the required distance between ground rods for effective grounding?
The required distance between ground rods for effective grounding is typically 6 to 8 feet apart.
What is the required distance between edge markers?
200 feet
What is the required distance between emergency exit doors for industrial buildings?
what is the required distance beteen emergaency exit dorrs for industrial buildings
Distance between doors and exhaust tip?
federal law 18 inches past the furthest opening window
As your vehicle moves closer to an object you will be required to?
Understand that there is no relationship between the amount of steering required and the distance you are from the object
What is the distance required between Mobile homes?
That would depend on where it's sited.
What is the distance between Crete and Jerusalem?
This is the approximate time required. The distance considered for the journey is the shortest route chosen between the places. Also traffic rules like one ways and no entries have not been considered.the time required between the above places is 44 hours, 1 minute
Distance from Baltimore to Pittsburgh?
This is the approximate time required. The distance considered for the journey is the shortest route chosen between the places. Also traffic rules like one ways and no entries have not been considered.the time required between the above places is 43 hours, 34 minutes
What is the difference between a furnace and a boiler?
A furnace heats air; a boiler heats water. --The HVAC Veteran
What is the code regulation for the conduit that the electrical wire goes through when going to the switch on a furnace?
The furnace control switch can be located on the outside of the furnace room. This is in case of an emergency with the furnace, no one has to enter the furnace room to isolate the furnace from its power supply. Code rule from the CEC (Canadian Electrical Code) 26-806 - 6 - The disconnecting means shall be permitted to be a branch circuit breaker at the distribution panel board, provided that the panel board is located between the furnace and the point of entry to the area where the furnace is located. 7 - Where a separate switch is required, due to the unsuitable location of the branch circuit breaker, it shall (a) not be located on the furnace in a location that can be reached only by passing close to the furnace; and (b) be marked to indicate the equipment it controls.
How much distance should you leave between trees?
This will depend on the type of tree and type of cover required.
