0
To remove the governor on a 1991 Dodge Stealth, you typically need to modify or replace the engine control unit (ECU) or adjust the speed limiter settings if applicable. This process may involve reprogramming the ECU with aftermarket tuning software or using a performance chip. It's essential to ensure any modifications comply with local laws and regulations, as removing speed governors can affect vehicle safety and legality. Always consult a professional or refer to specific service manuals for detailed instructions.
What else can I help you with?
1991 dodge stealth fuel pump problems?
WHERE DO YOU CHECK THE FUEL PRESSURE ON A 1991 DODGE STEALTH
What is the bolt pattern on a 1991 dodge stealth?
5x114.3mm
Whats is the registered speed for a 1991 dodge stealth?
160 mph
Where can you get a real factory service manual for a 1991 Dodge Stealth RT TT?
Just go to 3sx.com the have pretty much anything you need for a dodge stealth or 3000gt
Do you have to use premium gas in a 1991 Dodge Stealth RT?
yes, it is recommended
What is the fuel recommendation for 1991 dodge stealth?
91 octane/premium fuel
Does an ecu for a 1991 dodge stealth need mapped after installation?
No, that is for OBD2 cars.
Where is the fuel cutoff relay on a 1991 dodge stealth?
The 1991 Dodge Stealth fuel pump cutoff relay switch is located on the firewall in the engine compartment. You will find the relay switch on the drivers side of the engine compartment.
Srs 1991 dodge stealth?
Take it to the Dodge Dealership and let them either change the sensor or reset the system for you.
Where is the oxygen sensor location on 1991 Dodge Stealth?
they are located right at the exhaust manifold
Where is the ecu on a 1991 dodge stealth?
behind the radio across the back of the center console
Do you need an ecu for a 1991 dodge stealth?
Yes, the computer is required to run the engine.
