It is when u deposit metal
deposition
Deposition. Erosion is the process of wearing away or carrying away materials, while deposition is the process of dropping or depositing those materials in a new location.
Low deposition rate in sputter deposition can be attributed to factors such as low sputter yield of the target material, insufficient power or pressure to sustain sputtering, inefficient target utilization, or poor target-substrate geometry leading to inefficient material transfer. Increasing any of these factors can help improve the deposition rate in sputter deposition.
Most metal ores are deposited in the Earth's crust through a process called hydrothermal deposition. This occurs when hot water carrying dissolved minerals flows through cracks in the Earth's crust and deposits the minerals as the water cools. Over time, these deposits accumulate and form metal ores.
Weathering: disintegration, decomposition, deterioration Erosion: abrasion, corrosion, scouring Deposition: accumulation, sedimentation, deposit
A deposition in which two metal are deposit on a substrate.
deposition rate
Manual Metal Arc Welding
In an electro-refining system the deposited metal is collected without the need to remove the cathode from the slurry bath. The cathode has a hollow cavity permitting steam or hot water to be introduced to heat the cathode. During the deposition process, the heating of the cathode encourages the deposition process. When the deposited material is to be collected, the cathode is heated to "melt" the bonds between the cathode and the deposited metal. Using a bracket which was installed before the deposition process and into which the deposited metal has been formed; the now-released sheet of deposited metal is easily removed.
Layering a metal onto a surface typically involves processes like electroplating, physical vapor deposition (PVD), or chemical vapor deposition (CVD). In electroplating, an electric current is used to deposit a layer of metal onto a substrate. PVD involves vaporizing the metal and depositing it onto the surface under high vacuum conditions. CVD involves chemical reactions to deposit a thin film of metal onto the surface.
Probable the metal is protected by the deposition of marine materials.
Electrolysis is used in the extraction of metals from their ores by passing an electric current through a molten or dissolved metal compound. This process causes the metal ions to gain or lose electrons, resulting in the deposition of pure metal at the electrode.
A Backgouge consists of preparation of the second side of full penetration welds to the extent necessary to permit the proper deposition of weld metal.
Most hydrothermal deposits form from hot, metal-rich fluids that are left during the late stages of the movement and cooling of magma.
deposition
deposition
Deposition