answersLogoWhite

0

no because it has a low boiling point so will evaporate in vacuum and dissolve the solid clogging the filter paper

User Avatar

Wiki User

13y ago

What else can I help you with?

Continue Learning about Earth Science

What is a suction effect in a sinkhole?

A suction effect in a sinkhole occurs when water drains rapidly through the sinkhole, creating a downward suction force that can pull objects or individuals downward into the sinkhole. This phenomenon can be dangerous and poses a risk to anyone near the sinkhole when it occurs. It is important to exercise caution around sinkholes and stay a safe distance away from the edge.


Why must refrigerant in the suction line be slightly warmer than the saturation temperature?

Refrigerant in the suction line needs to be slightly warmer than the saturation temperature to prevent liquid refrigerant from entering the compressor. This temperature difference ensures that the refrigerant is fully vaporized before entering the compressor, preventing damage and maintaining efficiency.


What does the head pressure do if the suction pressure rise?

If the suction pressure rises, the head pressure will also increase to match the rise. This is because the compressor will work harder to maintain the balance between the two pressures to ensure proper operation of the refrigeration system. A significant increase in the head pressure could lead to compressor overload or system inefficiency.


What does the soil curve look like?

The soil curve, also known as the soil moisture characteristic curve, typically shows the relationship between soil water content and soil suction (or tension). It generally shows that as soil suction increases, soil water content decreases. The curve can vary depending on soil type and compaction.


What is the maximum suction lift of a solid column of water?

I must assume you mean uniterrupted column of water! The maximum suction lift of a column of water is the height of a column of water (inside a vertical pipe for instance) that can be supported by atmospheric pressure i.e. approx 14.69psi or 760mm Mercury. You should be aware that suction does not cause water to lift. Suction produced by various kinds of pump merely removes air from above the column of water and this allows atmospheric pressure to act upon the base of the water column. The water column is therefore pushed upwards by atmospheric pressure from below rather than pulled up by suction from above. The density, vapour pressure and surface tension of water vary slightly with temperature and atmospheric pressure also varies slightly with weather conditions. Thus the measured height of the water column may vary slightly according to the conditions prevailing when making the measurement. A good approximation at room temperature is 33 feet or 10 metres. Dan Hanlon

Related Questions

What is the principle behind suction filtration?

For contro solution


Why crystals disappear during suction filtration of a sample crystallized from benzene?

Crystals may disappear during suction filtration of a sample crystallized from benzene if the crystals dissolve in the solvent being used for filtration, or if they break up into smaller particles that pass through the filter. This can happen if the crystals are not fully dried or if too much force is applied during filtration.


Why Suction filtration is better than gravity filtration?

Suction filtration is typically faster and more efficient than gravity filtration because it uses a vacuum to pull the liquid through the filter paper or membrane, resulting in quicker filtration. Additionally, suction filtration is often more effective at removing smaller particles due to the enhanced force applied to the filtration process.


What are advantages to using suction filtration?

Suction filtration is conducted by using a water aspirator, suction flask and a Buchner funnel. The force of the water pulls the air out of the apparatus (assuming the funnel gets sealed, generally this takes place with your hand.) creating a great deal of suction.


How you increase the rate of filtration through gooch crucible?

To increase the rate of filtration through a Gooch crucible, you can try a few things: use a vacuum filtration setup, reduce the particle size of the substance being filtered, apply gentle suction to the filter paper, and ensure that the crucible is properly packed with the filter aid to support faster drainage.


Why buchner filtration chosen for filtration?

Buchner filtration is chosen for filtration because it allows for the separation of solid compounds from a liquid by using vacuum suction. This method is commonly used in laboratories as it is efficient, quick, and requires minimal manual manipulation. Additionally, Buchner filtration is ideal for separating precipitates or solid particles from a solution without the need for filter paper.


Why is it advisable to break the suction filtration before turning off the water pump?

Breaking the suction filtration before turning off the water pump helps prevent air from getting trapped in the system. Trapped air can cause the pump to lose prime and may lead to inefficient filtration or damage to the pump. By breaking the suction filtration first, you allow water to flow freely and avoid introducing air into the system when the pump is turned off.


Why can't you use vacuum filtration for filtering a hot saturated solution?

The lower pressure of the suction flask would cause the filtrate to boil. If this happened, the material in solution would be deposited over the walls of the flask.(From Techniques and Experiments for Organic Chemistry by Addison Ault)


What is the function of a suction and discharge strainer?

Suction strainers offer front-line fluid filtration in the tank, used to prevent large particles of sediment, sewage, mud, or solids from entering suction port of drainage pumps.


Why the suction of a vacuum filtration apparatus is broken before the vacuum is turned off?

Releasing the suction of a vacuum filtration apparatus before turning off the vacuum prevents any potential backflow of liquid into the vacuum pump, which could damage the pump. It also helps to avoid contamination and spillage of the filtrate.


How gooch vrubical invrease the rate of filtration?

Gooch Crucible is made up of porcelain. It has a perforated bottom which is covered with paper pulp or a filter paper cut to its size. In order to increase the rate of filtration, the crucibles are placed in a suction filtering apparatus.


What is the difference between purchasing a vacuum that requires a bag and one that does not (besides reduced cost)?

The newer vaccum taht do not have a bad normally offer superior filtration and suction.