To remove the manual shifter knob from a 2003 Saturn Vue, first ensure the vehicle is in neutral and the parking brake is engaged. Look for a small set screw or a retaining clip on the shifter knob; if present, use an appropriate tool to loosen or remove it. Once the screw or clip is removed, pull straight up on the knob to detach it from the shifter shaft. If it’s stubborn, gently rock it back and forth while pulling upward.
how to remove trans shifter cable ball socket from shifter ball
how to remove and replace broken antenna on a 2003 Saturn ion
remove 2003 Saturn vue radio
Dealer
To remove the top of the shifter on a 2003 Chevy Cavalier, start by prying off the decorative trim piece around the shifter using a flathead screwdriver or trim removal tool. Once the trim is off, you should see screws or clips holding the shifter cover in place; remove these fasteners. After that, carefully lift the shifter top off, ensuring not to damage any wiring or components underneath. If necessary, consult a repair manual for more detailed instructions.
steering wheel
Haynes has not yet written a manual for the Saturn Vue. You may have to go to the dealership and order one. I do not have a part number. Haynes now has a manual available at Autozone
The manual transmission pressure switch on a 2003 Saturn Vue is typically located on the transmission itself, near the valve body. It can often be found on the side of the transmission case. To access it, you may need to remove the transmission pan or other components, depending on the specific configuration. Always consult the vehicle's service manual for precise location and removal instructions.
You should just unscrew it off the shifter. It might be on there tight, but it should just screw off. I put the stock shifter knob on my B&M short throw shifter
i wont to change my shifter but cant take off old one
you have to putt the dash apart starting with the shifter knob, have fun.
To replace the gear shifter cable on a 2003 Hyundai Tiburon, first, disconnect the negative battery terminal for safety. Remove the center console to access the shifter assembly, then detach the old cable from the shifter and the transmission. Install the new cable by securing it to the shifter and reconnecting it at the transmission, ensuring proper alignment. Finally, reassemble the center console and reconnect the battery.