th the back seats up and locked do the following;
1z0 reach your fingers back behind the cushion where the back of the seat meets the bottom on one side or the other, it doesnt matter. pull it up till it feels like its bending. it will stay in place.
2) repeat the same procedure on the other side then stop do the other side. only till it bends. stop. the middle section between the 2 seat belts is still flat and appears to be in place.
3)now pull up the middle section grasping the outer most parts of the center cushion firmly. you will hear the rear mounts pop loose and the seat will rise immediately. dont pull it up more than a few inches. let it rest slightly elevated. stop
4)now move the front seats as far forward as possible, youll need all the room. kneeling in front of each corner, slide your fingers in under the seat as far as you can and still get a grip, and pull upward, fast and HARD. it will pop up quick, just like the rear outside ends did. do the same anon the other end and gusto its ready to pull out. pull forward and lift up at the same time. it is now out. it looks and seems like you are bending thee seat and doing damage. but there is no frame in the lower cushion at all. it weighs about fifteen pounds and straightens right out when you lay it down on the floor.
5) reverse to install. you will feel it pop back in as you push down at each point you pull at earlier. total time 1rst attempt 8 minutes. second ttime 45 seconds (out and back
look at the mounting point before you reinstall and you will see clearly how it works.
good luck and pull hard!
How do I put the back seat bottom back in my 2002 Saturn L200? The Mechanic took it out and did not replace it. How do I put the back seat bottom back in my 2002 Saturn L200? The Mechanic took it out and did not replace it.
The rear seat is not designed to be removed. You can remove the center seat and slide the rear seat forward.
Remove the bolts fastening the rear seat cushion (Figure 7.52).Remove the rear seat cushion assembly.Remove the screws and remove the side rear seat back (Figure 7.53).Remove the lower bolts fastening the rear seat back.Tightening torque - 17-26 NmFlip forward the rear seat back, remove the bolts and remove the back seat.Tightening torque - 17-26 Nm
The rear seat isn't designed to be removed. If you have a center bench seat you can remove that by unclipping it, then slide the rear seat forward.
The rear seat is not intended to be removed. You can remove the center seat and slide the rear on forward into it's place.
How do you remove the rear seat on a 2002 diamante
Remove rear seat and panel underneath seat. How do I remove rear seat?!?!
remove the 2 bolts on the floor in front of the seat, and the 3 bolts on the floor at the rear of the seat.
you must remove the bolt behind the rear seat and remove the rear seat then you will see 2 small Allen head bolts remove them and the seat will come right off.
You need to remove the rear seat before you can removed the front. First removed the one screw on the back of the rear seat then removed the two screws on the front of the rear seat. You can not get to the front screws until you remove the rear screw.
Remove the 10mm bolt from behing the rear seat. Then pull the rear seat it hooks to the front seat in the front. Remove the bracket there and pull the front.
Remove the rear seat screw. Then pull the rear seat to the rear and slightly up. It is held in by two metal tabs that slip under the front seat lip.