0
What else can I help you with?
How do you replace blend door actuator motor on 1999 ranger?
how to replace a blend door actuator on a 1999 ford ranger
How do you replace dashboard lamps on 1999 Saturn SC1?
Remove the instrument cluster then replace the bulbs. = =
Where is the pcm on a 1999 s series Saturn?
To the right of the glove box.
Where is the 1999 Saturn sl-series knock sensor and How do you replace 1999 Saturn sl series knock sensor and the torque to tighten it?
The knock sensor is located on the backside of the engine to the left of the oil filter, it is round with a 1 wire plug on it and a round base. I do not know the torque spec, but when I replaced mine I made it tight enough not to back out on its own.
How do you replace the piston rings on a 1999 Saturn SL2?
If you are mechanically inclined it is cheaper to replace the entire engine
Does a 1999 4-cylinder sl Saturn have a timing belt?
( no ) The 1.9 liter four cylinder engine in a 1999 Saturn S series has a timing CHAIN
Where is the air pump on a 1999 Saturn S-series?
Behind the right headlight .
How to replace the passenger air mix actuator on 1999 Buick Park Ave?
To replace the passenger air mix actuator on a 1999 Buick Park Avenue, start by disconnecting the vehicle's battery for safety. Remove the lower dash panel on the passenger side to access the actuator, which is typically located behind the glove compartment. Disconnect the electrical connector and remove the screws securing the actuator in place. Install the new actuator by reversing the removal steps, ensuring all connections are secure before reconnecting the battery.
How do you locate replace fuel pump on a 1999 Saturn sl2?
It is inside the fuel tank
How do you replace the factory sunroof on a 1999 Saturn SL2?
Contact The Sunroof Doctor for replacement parts & assistance for your Saturn sunroof. http://www.sunroofdoctor.com/9602saturn.htm
Replace door lock actator on 1999 gmc suburban?
To replace the door lock actuator on a 1999 GMC Suburban, start by removing the interior door panel, which involves unscrewing any visible screws and gently prying off the panel clips. Once the panel is off, locate the actuator, disconnect the wiring harness, and remove any retaining clips or screws holding it in place. Replace it with the new actuator, reconnect the wiring, and reassemble the door panel. Finally, test the locks to ensure the new actuator functions properly before securing everything back in place.
How do you replace front speakers in a 1999 Saturn sc?
Remove the inner door panel.See link below.
