0
What else can I help you with?
What determines whether an openpit or shaft mine is used?
Well since guy rather have a loos whole and usually guys will work in a mine they would use a open pit mine since it is bigger than a shaft ( small whole mine)
Which shafts are present in a car?
Axle shaft, steering shaft, drive shaft, distributor shaft
On a 2000 Chevy tracker with a two piece drive shaft can you replace just the carrier bearing without the entire drive shaft assembly?
I have a 98 4dr trackertwo wheel dr. autotrans with a two part shaft with center support assembly consisting of cv joint and rubber vibration dampner with spline. This shaft is approx $1000.00 from dealer. Apparently instead of rebuilding, a straight shaft is offerd for a fraction of the cost. however I was told this may stress the drie train (trans/differintial?).or cause vibration posibly from engin harmonics? Check with Rockauto.com for shaft and have picture emailed. personally. Id rather spend $250.00 for a straight one and take my chances. I also need to ask myself why do they (CARDONE) make the stright shaft if it dozent work. Who do I ask if it does work> The shaft this guys mentions is a front shaft, not the 2 piece shaft that is required. They do not make a straight shaft. Junkyard or new is the only way to get what you need. For a 4dr 4x2 automatic.
What is a guys fore skin?
The skin on the shaft of the penis extends over the head. All males are born with foreskin and for religious reasons or parents choice some are circumcised, the foreskin is removed.
Is a flex shaft a regular shaft?
A regular shaft has regular flex.
What is another name for a driveshaft?
driving shaft, propeller shaft, Cardan shaft
What center shaft would spin freely around on 360 degrees without moving up or down I need the part name for my project. Thanx Guys.....?
I would say an axle or a rotor. : )
Drive shaft and intermediate shaft the same?
is the drive shaft the same as the intermediate shaft on a vauxhall corsa car does any body no
What does the intermediate shaft do?
The intermediate shaft is the shaft going to the driver side wheel from the tranny. The shaft is suppose to eliminate what you call torque steer, It comes straight from the tranny and bolts to the engine block with a bearing race to hold the shaft and at that brace is where the half shaft, or drive shaft connects to the intermediate shaft and to the driver side hub.
What dos the shaft do?
The intermediate shaft is the shaft going to the driver side wheel from the tranny. The shaft is suppose to eliminate what you call torque steer, It comes straight from the tranny and bolts to the engine block with a bearing race to hold the shaft and at that brace is where the half shaft, or drive shaft connects to the intermediate shaft and to the driver side hub.
What is tail shaft?
Tail Shaft is the section after the propeller shaft of a shift. Any shaft is always placed farthest from the head, where the power is applied.
Who was the director of Shaft?
The director of Shaft (1971) was Gordon Parks.The director of Shaft (1972) was Gordon Parks.The director of Shaft (1973) was Gordon Parks.The director of Shaft (2000) was John Singleton.
